SA to FC Wheels with a Spacer.
Thread Starter
Junior Member
Joined: Mar 2017
Posts: 25
Likes: 4
From: Atlanta, GA
SA to FC Wheels with a Spacer.
I have what might be a very stupid question, we will see 
.
Im doing a project converting an SA to an Renesis engine and want to put bigger brakes on it. To facilitate that FC wheels look like the way to go. I just did a quick measurement of some wheels I have around and the offset of SA wheels is about 4 2/4 and FC wheels are 5 1/2. Would a spacer that's lets say 1 3/4 pull the offsets to about equal so it would look right on the car?
.Im doing a project converting an SA to an Renesis engine and want to put bigger brakes on it. To facilitate that FC wheels look like the way to go. I just did a quick measurement of some wheels I have around and the offset of SA wheels is about 4 2/4 and FC wheels are 5 1/2. Would a spacer that's lets say 1 3/4 pull the offsets to about equal so it would look right on the car?
The factory 1979-1883 wheels is 5Jx13 ET20. So ET20 is +20mm offset.
The second gen has 14 and 15" wheels but it looks like the offset is the same. +40mm offset
5.5Jx14 ET40
6Jx15 ET40
The second gen has 14 and 15" wheels but it looks like the offset is the same. +40mm offset
5.5Jx14 ET40
6Jx15 ET40
Last edited by KansasCityREPU; May 10, 2022 at 02:53 PM.
Thread
Thread Starter
Forum
Replies
Last Post
ProjectR13B
1st Generation Specific (1979-1985)
5
Dec 31, 2006 01:44 AM
Rxmfn7
2nd Generation Specific (1986-1992)
1
Nov 12, 2003 04:12 PM