What hole do you guys use to run wires through the firewall???
#1
Rotary Enthusiast
Thread Starter
What hole do you guys use to run wires through the firewall???
Hey guys,
I am on the final stages of installing my DRl for inspection! I found where all of the wire go and now i am just installing the wires so everything looks clean.
I need to run a wire to the fuse box from the front right headlight... But i could not find an easy access through the firewall. I tried the hood cable hole, but the rubber grommet didnt fit after i ran the wire through. I am only using 16 guage wire.. but it still wouldnt fit.
Where do you guys typically run your wires through the firewall???
Remember that my car is RHD and that my fuse box is on the right side of the car.
Thanks a lot.
=Ben
I am on the final stages of installing my DRl for inspection! I found where all of the wire go and now i am just installing the wires so everything looks clean.
I need to run a wire to the fuse box from the front right headlight... But i could not find an easy access through the firewall. I tried the hood cable hole, but the rubber grommet didnt fit after i ran the wire through. I am only using 16 guage wire.. but it still wouldnt fit.
Where do you guys typically run your wires through the firewall???
Remember that my car is RHD and that my fuse box is on the right side of the car.
Thanks a lot.
=Ben
#2
Super Moderator
iTrader: (148)
there is a hole behind the pedals. Pull your front left fender liner and you will see the grommet hole. Just take your time and don't drill new holes in the firewall...
https://www.rx7club.com/showthread.p...ommet+firewall
you can search "grommet and firewall" and you will find many links on this subject
https://www.rx7club.com/showthread.p...ommet+firewall
you can search "grommet and firewall" and you will find many links on this subject
Last edited by caredden; 12-01-07 at 03:16 AM. Reason: found a link
Thread
Thread Starter
Forum
Replies
Last Post
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM
befarrer
Microtech
3
08-22-15 05:52 PM