could someone take micrometer and take measurement of the outer and inner diameter of the dowel pins that extends from the rear iron to the transmission? would be nice if I can get outer diameter to the 1 thousandth or to the smallest decimal if measured in millimeter. I don't think inner diameter would matter too much.

I'm using quicktime bellhousing for T56 swap and I realized need to make custom longer dowels with the same diameters. thanks in advance!

 

anyone?

 

my digital micrometer battery went dead unfortunitly

 

Nothing where the bits are located - and I probably wouldn't be too trusting of some random off the internet supplying anything precise with possibly a dropped mike - vernier indicates 15mm dead nuts fwiw. Wouldn't worry about ID, - edit, sorry they're through bolts on the dowels (yes?) 10mm bolts on a FD, so should be easy enough to work around.

 

excellent, thanks!! 15mm is what I also have going off the dowel hole.