Wiring the pop up FD headlights on a stand-alone toggle?
#1
Junior Member
Thread Starter
Join Date: Dec 2017
Location: Austin, TX
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Wiring the pop up FD headlights on a stand-alone toggle?
Pulling some unneeded wiring on the ole rx7 and since I’m going with all new gauges, it seems I don’t need anything from the instrument harness. Everything except the pop up button that is.
If I were to wire the headlight pop ups on it’s own stand-alone harness and used a toggle, how would I go about doing that?
The lights themselves run off the front harness, so that’s not an issue. Just need them to pop up and down.
I’m not too savvy with wiring, so bare with me on the questions.
Thanks.
#2
Moderator
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,805
Received 2,577 Likes
on
1,831 Posts
since they already are on a toggle, you just extend factory wires, and hook them up to a switch of your choice
#3
The Ancient
#4
Junior Member
Thread Starter
Join Date: Dec 2017
Location: Austin, TX
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
What are the R/G and R/B wires for? They aren’t on the wiring diagram, but they are notated on the connector diagram.
Thread
Thread Starter
Forum
Replies
Last Post
brownmound
1st Generation Specific (1979-1985)
8
01-02-02 05:01 PM
lerch32
3rd Generation Specific (1993-2002)
5
12-11-01 10:44 AM
dbb280zx
1st Generation Specific (1979-1985)
9
09-02-01 12:33 AM