- vacuum line question regarding BNRs stage 3 non sequential
- Borg Warner 380
- dyno graph and picture gt42
- quick spool valve
- Stock S5 Waste Gate Problem
- Stock S5 Waste Gate Problem
- boosting s4 NA gxl fc
- Welding wastegate to turbo exhaust housing
- Single Turbo Harness Help
- Fuel Pressure not increasing !!!
- Single Turbo Kit pricing
- Got a free turbo!
- need help with turbo selection
- knock sensor & aftermarket ECU
- WTB Broken Apexi Isamu IHI RX6 Turbo
- 30-130mph
- anyone using RPM rails and ID injectors?
- rotary engine VE and the future?
- T04E setup
- need to find greddy t78 compressor wheel
- Gt40r or Holset hx52 ?
- Help a newb! Looking to buy a single turbo car
- magnecor r100 spark plug wire boots and terminals
- Finally an affordable manifold. ( TRACKFORGED )
- injectors sizing for my setup
- Spark Timing
- are we tuning too rich????????
- RX7 Store GTX35
- What Turbos work with Greddy Manifold?
- 88 turbo II rebuild
- Please your advice GT3574 ASpec vs BW S366 Himni
- What size i/c piping for 3rd gen?
- which turbo to use
- Fuel line routing?
- Rotary baja exhaust idea and blow through Nikki
- Potentially free Turbo, Is is crap?
- Hx55
- turbo help needed.
- Hitachi HT-18 questions
- Need opinions on GT37 Please
- BORG WARNER S366 power levels on race gas?
- failed emissions question No flaming please...
- Would a single 38mm wastegate be to small
- Rotor housings from a 6 port 13B
- Injector Dynamics=Bosch NGI2?
- T04s with 4 1000cc injectors?
- 500+ 13b w/ T78
- BB Turbo Assembly
- side seal clearance/ fuel line size
- Single Turbo Harness + Coolant Level Sensor = Frustration
- t04e what to expect
- Deciding To Go Single
- 3in to twin 2.25in exhaust- (GT35) How much power/spool are we leaving on the table?
- Fc setup questions
- Hx-40
- Recommendations on turbos
- Building for response, gt35r too laggy for me?
- 2000cc Injector question...
- FB 13B S400 10.5@20psi EMS-Rtech
- Simple External wastegate mod / Tuning question
- wastegate ?
- heat that IC pipes are subjected to?
- T3 or T4 size blanket for GTX35R?
- bw S362 FMW
- gt40r Half Bridge..... reliable ? drivable?
- Oil cooled turbo - What to do with factory coolant lines
- New ignition setup... inductive or CDI?
- Turbosmart powergate 60
- Help with Identification of Turbo
- Building a manifold for a HBP, hx40 hill climb rx3
- Rough idle
- Where to rebuilt 500r
- Boost goes up with rpms?
- Re-using rotor housings with gourges from damaged apex seals in the exhaust port area
- What turbo are you running on your bridgeport?
- Primaries failing???
- Anyone running a duramax turbo?
- Ignition Coil question
- 13B turbo manifold material- Strong as an Ox please!
- Whats the best?
- T3 super T70???
- Favorite Single Turbo set-up and why?
- Wastegate runner plumbing
- GT4088R info
- Blitz SBC-iD boost controller and Tial wastegates
- Fuel setup: guidance needed
- Need a short filter for my GT45R....
- best port for GT35R T3 1.06
- Swap Microtech LT8 with PFC
- Whats wrong with running 100% duty cycle on injectors
- Urgent! Turbo flange undivided or divided?
- Running 6 injectors with fjo box and power fc
- Tial SS Housing
- Coolant in downpipe
- Help with injector choice for fd runnin m2r
- T3 Turbo manifolds
- Removing double throttle blades
- Aeromotive 340 Stealth Fuel Pump
- What to expect with this setup?
- 85 GLS-SE Turbo Questions
- atkins apex seals
- new turbo"s project
- single turbo setup
- A few questions for people running SS wastegate lines w/ an EBC
- The oldest single turbo setup ever?
- Single turbo with no coolant cooler?
- Spring's for Tial MVS external wastegate
- OMG LOL... my ears are F'n RINGING!!!
- Manifold needed for HX52?
- My Current build
- Himni Turbo Kits GTX3582R
- Efr 7670
- Anyone running a bullseye s368?
- GT45R upgrade
- Isis Multi-Plex Help !!!! ???
- How to size fuel injectors for your app
- ID 2000's Worth It ?
- turbo talk!
- GTX4294r or GT4508r for my 20B?
- split w/g downpipe for stock s5 turbo? would it work? available?
- Holset HX52 oil feed/drain
- Aftermarket Twin Turbo Guidance Needed
- Injector setup question-
- nob with a turbo question
- Precision 6765 turbo too small at 20+ psi????
- FC NA rotors in Turbo setups
- single turbo mani help
- identifying turbo
- power w/ a gt4088r
- New Precision turbo CEA turbine wheels?
- I need a good FC manifold!
- noob still
- trust wastegate spring
- gtx2867r bb turbo
- Does the Greddy or HKS manifold work with an S366?
- Batmowheel turbos
- Garrett T04B71
- manifold runner size affect on spool and flow
- Need help trying to rough together a single turbo setup
- Hybrid turbo H3 compressor wheel?
- GTX4294R Dyno Pulls
- S5 rotors in a turbo 2
- Turbo Help
- Drain line question
- Updating the Single Turbo FAQ section.
- Anyone try NGK BRxEYA's?
- Primary Injector Question
- Anyone running a Precision 6465?
- walbro 400lph?
- help me identify wastegate size
- (turbo newb alert) oil smoke after t04b/ht18 hybrid FC
- Fuel Rail and Fittings Question
- Fueling for A-spec 3574R
- Rear rotor leaner then front - Causes?
- Single Turbo T4 Manifold Options
- Turbo Question/Help
- Help! What turbo is this...
- Does this seem right? 539rwhp @ 20 psi
- custom hybrid turbo questions
- turbo manifold fitment with my T66
- Turbonetics T66 max rwhp with bridge ported 13b
- Fuel Pressure? what psi
- problem with a-spec 3574kit
- do i need a restricter
- turbo 1/2 bridge project
- Intercooler pipes and couplers
- Injector Placement
- What you guys think about this.
- turbo blanket
- picture request! turblown TD61
- cleaning O2 sensor
- Comparison of older style Bosch EV1 vs newer Bosch EV14 injectors
- Glowing manifold at idle
- Limits Of Pump Gas (93) And Realistic Goal Questions Per My Build
- Engine build recommendations
- My first ever dyno session. Self tuned 423rwhp at 18psi.
- 3rd gen fuel calculator is crazy lol
- Billet 6062 Dyno Results
- 360° thrust bearing and dynamic seal
- Tial MV-R Wastegate Testing
- anyone know how to set timing on a rebuild motor ?
- Borg Warner S362 - efficiency
- Aftermarket/hydrid/rebuilt S5 T2 turbo id
- Shooting for 400 WHP, any input would be great
- caterpiller t04b?
- Anyone realized any negative/catostrophic effects fro running too much IG split.
- 88 s4 turbo swap overheating help!
- hbp failure and new build
- bw s372 hot side size ?
- can I use a 3" RB donwpipe to a T04z?
- I am seeing 1680F egt on my rear rotor at 16psi is this too high?
- anyone running premix, how much per tank?
- options for oil and water lines.
- Need help asap fuel system question after going single
- Ebay Turbo Setup Anyone??
- What turbos are similar to the Apexi RX6?
- Synapse Synchronic WG & AVCR EBC setup
- IS my Fc ingition not going to be enough for e85 around 15-19 psi?
- single turbo over twins?
- Observations of Spark Plugs when using WI with OMP converted to 2 cycle oil
- Need to repair a GTX42R...turbine wheel was chewed up a little :)
- aNYBODY USING AN RX7STORE.NET V MOUNT KIT??
- s362 e85 fuel question
- bridgeport single turbo fd video
- Eliminating Oil fill neck, need PCV help
- Walbro 400lph Pump
- Looking at Buying an FD with a single turbo conversion .
- Still wondering(power questions)
- finshing my single turbo but have questions
- Dyno tuning......tips / methods
- Garrett Gt35
- Lag Time for Bosch & Siemens Injsectors
- If it were your choice what which housing would you place a single knock sensor
- Ebay FD T4 Manifold Review
- Whats the best turbine housing for my build?
- gtx3071r-gtx3076r in fd???
- manifold suggestions for borg warner 366 1.0 AR hotside?
- Does any one here know the output voltage range of Mazda factory knock sensor
- Need some specs on a Deadbolt enterprise s5 hybrid
- Disassembled Turbo Manifold?
- finally tuned up billet 6765 on pump and race gas.. vids.
- Injector cycle duty? 87-90% in 3rd @ wot on To4s.
- timing ?
- At what rpm range would you say peak torque would be located on a LSP rotary.
- single turbo DP
- Dual Walbro Setup (and other fuel questions)
- Timing or AFR?
- The last days of my GTX3582R build
- Looking for a responsive turbo for my setup
- How does 30* advance sound for 5psi at 6000rpm on a large street port sound
- GTX3582 1.06 a/r
- Borg Warner Batmo wheel and cover
- external Wategate
- Borg warner EFR
- T04Z vrs GTX3540?
- aspec gt3574
- Manifold problems
- New Options For the S366 91-79(80)
- Sump tank return line question
- Rebuilding Greddy Wastegate - Need Help Finding a Diaphragm
- which pump to run with 20 psi on t61?
- whats the best turbo for a stock port fd?
- Fuel System Kit Prices
- Help
- setting up a 2 step/anti lag....
- t66 line plumbing question?
- Manifold needed to fit Holset hx52 in FD
- Silencer question
- Turbo Compressor Map w/ 13B Flow Plots
- Mazda scientifically tests oil vs water cooled turbos