- tranny problems
- Fuel pump rates for differen gen rx's
- Blitz Duo Turbo Timer Wiring and Operation
- side seal question
- need help with water pump
- blown seal or metering pump?
- Tuning, Widebands and EGTs
- engine swap
- What sort of flywheel do I have?
- Gxl to turbo 2nd gen
- Is there any Rotary Schools out there?
- Question concerning engine swap
- High rpm Problem
- High rpm Problem
- p/s - switching to ATF
- 3000gt intercooler in a t2
- must the radiator flow vertical?
- Help- intake will not come off, am I missing a bolt or something?
- AIR BLEED for cooling system...anyone?
- Synthetic Oil to NON-Synthetic, problems??
- Strange sound...
- Exhaust sleves
- What EMS should I get??? (2nd gen TII) with mods
- Calculated Accurate Exhaust Size
- transmission problems
- 13B-RE or 13BT?
- Dash lights/ taillights/ speakers don't work--help
- G-Force GF-5R gearbox opinions
- 3mm APEX seals
- Change Auto trans fluid and no the car wont start...WTF!
- stock motor bosting ?
- CLANK!..."what was that?"
- 13bre into fd
- heat sink compound
- Alternator Issues
- Engine Possibilites
- cosmo vs 13brew..
- rotary porting midwest/indiana
- Overheating Engine !!
- This just sucks....
- 12a Turbo kit?
- 12a Turbo kit?
- Re-Build it yourself - Easy?
- uhh...reliable or not?....
- How long does a BP 12a last..??
- HELP! need advice on damaged rotor and chamber
- I need electric help
- 91 gxl check engine light
- Batery of alternator!!! what do you think
- How would you guys handle a seven engine fire?
- Fuel pump connected in series
- Fuel flow rate sensor/gauge?
- oil injector plumbing on 13b
- serious ? about engine swap
- Has anyone ever used 6mm apex seals?
- Need help tuning a sidedraft on GSL-SE
- [B]Can I use the short block turbo engine with nun turbo rotors?[/B]
- Rebuild 13B
- ??? will a 91 stick motor in a 91 auto rx-7
- Boosting
- need help with oil pan
- 4-piston brakes????
- HELP direct fire
- Changin Ova...Help
- RX7 Glossary?
- 90 Mazda Rx7 - Oil Metering Pump
- 1994 Type-R Leaking water ?? HELP...
- Mazda Bolt Thread sizes.
- Mazda Bolt Thread sizes.
- replacing cracked intake mainafold need some help
- N/A to T3 super60--HELP
- Security Alarm System Problems
- Warrant issues with RX-8
- Autometer A/F gauge problem
- Which injectors are these?
- cant find in FAQ or search
- chasis question.
- G-tech
- my rx-7 has poor idel
- boost surge under hard roll on pulls
- Crazy noise....need help!!!!
- Timing Questions??
- Timing Question
- symptoms of a failed oil seal
- Aftermarket 20b manifolds.
- experience with castrol syntec...
- Lighten rotors?
- question about iridium spark plugs
- how do I install Block-Off Plates?
- how to install Block-Off Plates
- Finished rebuild 90 RX7 No start.
- New here, building car
- Are those cheap ebay apexi style muffler just as good as the real deal?
- engine pros I need some help!
- Ports?
- Using RX7 engine in a track day car project
- 93 type s running a bit lumpy...
- Questions for Chemists...
- Little Smokey
- What engines could i use to put in my rx7 while using the stock tranny?
- unknown engine year
- got an odd question
- going to dealer with NO emisions
- rebuilt engine...wont start..want to cry!!!
- LS1 FC Has any one done this personally or know some one personally?
- rotor front rear?
- 91 RX7 - engine bogs down at 2k rpm, Help!
- STORAGE of RX7
- Check out what we got at the dealer today (pics)
- Ecu question
- timing light for rotary engine?
- Tacho problems
- define: surging
- Ignition coil question
- Water pump
- Engine bay schematics
- starter? please help, and tak
- engine runing to ritch
- question on underdrive pullys
- the return of white smoke
- Whats the best sounding and perfoming exhaust 94 rx7??
- We got 21 members in the RX7club Folding Team!!
- Hey everyone , What is the best exhaust setup
- Hey everyone , What is the best exhaust setup
- Porting S4-S5 waistgate
- stock 20b
- VRIS in RX-7s?
- Problems Starting
- Jerky acceleration, fuel pressure, or fuel flow?
- T2 swap into 1st gen.?
- New Rotor Housings Vs. Good 2ndhand Housings???
- It almost starts - 87 RX7 2nd gen
- Electric problems
- Leaky radiator
- Just Got 86 Rx-7 Need Help
- need help. a/c problem
- I think i added to much oil....
- gas
- Weber Woes
- Trailing Spark Plug
- Studders between 4-5thousand RPMS
- new buttons for rotors
- viton corner seals (93 FD)
- New Housings
- Searching for OEM Parts
- little r/ l dial
- Need help with jets for a Weber DCOE 48mm
- Anbody had ignition problems? Please help!
- rotary weight???
- building a rotary bike (atv)
- setting
- buying guide
- battery
- 9lbs rotors
- inlet manifold questions
- Overheated on freeway.
- 02 sensor/cat problems...
- How tight should exhaust be tightened?
- New to Site. Questions
- Electric problems
- insurance group
- speedometer doesn't work...
- Help with thread.
- 12A Carbed, need intake system..
- push start
- Fan Problem!?!?
- S4 NA and TII rear stationary gears the same?
- RX8, Does it have an OMP?
- What tool do the Pro's use to fix Rad fins?
- HELP, oil leak...Cant find it
- Thread Size
- Oil cooler cleaning...
- Stupid question regarding breakin and rebuilds & such
- how do i move J-spec to A-spec
- boost problem
- rough running
- Can I use this counterwieght?
- ping problem
- Are there any problems with "quick drain" oil plugs?
- intake confusion?
- My latest project: streetport 12A buildup, installation 1
- Little green pellets in engine? What is this?
- Miata with Rotary swap?
- Anyone have info on JR's ROtary Performance?
- Anyone have a contact in a Mazda Spares department?
- Here We Go, Another Newbie
- were to get my motor rebuilt
- rx7 newbie...need help
- power problem
- Going to AN Fitting on the Fuel? Size?
- direct fire
- I'm after some left-hand drive bits for my racecar
- microtech mt-4
- Test drove 93 RX-7 this is the list of probs..
- fc question
- newbie fuel question
- New car, need help
- starting problem help please
- help please
- No coolant going to new radiator
- Help Quick! Engine Dies!
- whats better single turbo or twin turbo non sequential???
- t2 swap gone wrong!! PLZ HELP!!!
- Overheating
- Corner seal removal
- NEW OilCOOLERS
- Which Rx carbys are interchangeable
- engine heating problems
- runs funny
- Fuel starvation??
- indesperateneed
- Help. No lights electrical problem
- Weird problem while removing Exhaust manifold...
- How to clean the gunk off the engine
- Transmission stuck in fourth gear???
- What kind of oil do you use?
- Air Leak
- Is sustained engine braking bad for engines on premix?
- Does 13 in 13B stand for 1.3 liter ?????
- noob question: hold down accelerator, revs drop after few secs
- 86 GXL taking 3-5 seconds to start
- Coolant...help please
- Can I use a true wide band O2 with my Greddy O2 gauge?
- Positions of coolant buzzer and position of coolant senso
- Punch out a rotary?
- can some one help
- AC problems
- Starting Problems...
- could use some help with my investment!!!!
- first time rotary owner
- junkyard supercharger project- fuel system help...
- gauge lights are not working
- Bad idea to powdercoat rotor housings?
- little big problem :P
- Rebuild, have rebuilt or JDM?
- Add coolant light
- Oil leak Help Please!!
- Engine at warm temperature wont hold idle when revving engine up at idle
- Side Housings: Why Iron and Not Aluminum?
- What's the difference between 1...n conductor wire?
- Does anyone make a dual needle water temperature gauge?
- yes this is good right
- Anyone No?????
- What happened
- Size of injectors
- 84 GSL SE 13B Intermittent Erratic Idle
- Getting grey smoke from exhaust
- Can someone tell me what this is?
- 87 Turbo II tranny, driveshaft, and rearend into 86 N/A Rx-7
- injector part # check-please