Blitz Duo Turbo Timer Wiring and Operation
10-14-04, 05:54 PM
#1
Driving RX7's since 1979
Thread Starter
iTrader: (43)
Join Date: Aug 2001
Location: So Cal where the OC/LA/SB counties meet
Posts: 6,096
Likes: 0
Received 8 Likes
on
8 Posts
Blitz Duo Turbo Timer Wiring and Operation
DIAGRAM
FATT
Purple --- Hand Brake
Orange --- Speed Sensor
White --- Shift Lock (Auto)
Red --- 12 Volt
Blue --- Accessory
Green --- Ign. "on"
The timer will not come on until the ignition is in the "on" position.
Blitz Dual Turbo Timer Operation
The timer has five modes: Boost, Peak, A-Set, Set, and Off. To cycle through them, press the power button.
Boost: Displays the current boost level. Press the MINUTE button to toggle auto-countdown mode, indicated by a small "A".
Peak: Displays the maximum level of boost achieved. Press the SECOND button to reset the current value. Press the minute button to toggle auto-countdown mode.
A-Set: Displays the countdown time to be used if you shutdown with auto-countdown activated. This value changes in real-time depending on driving condition. You cannot modify this time
Set: Displays the countdown time to be used in manual mode. Press the MINUTE button to cycle 0-9 minutes, press the SECOND button to toggle from 0-50 seconds in 10 second increments.
Off: Turns the unit off completely.
The unit will perform a countdown when you shut off regardless of what mode you are in, except Off.
When you shut the car off, the display will turn red and begin countdown. At this point, if you are in manual mode, you can press the MINUTE and SECOND buttons to add more time to the countdown.
Auto-mode defaults to 10 seconds. Even after running at periods of high boost I haven't seen the auto-mode indicator go above 39 seconds. It's been the consensus so far that this is not enough time... Stick with manual mode.
Found this on a Google search. Hope this helps
FATT
Purple --- Hand Brake
Orange --- Speed Sensor
White --- Shift Lock (Auto)
Red --- 12 Volt
Blue --- Accessory
Green --- Ign. "on"
The timer will not come on until the ignition is in the "on" position.
Blitz Dual Turbo Timer Operation
The timer has five modes: Boost, Peak, A-Set, Set, and Off. To cycle through them, press the power button.
Boost: Displays the current boost level. Press the MINUTE button to toggle auto-countdown mode, indicated by a small "A".
Peak: Displays the maximum level of boost achieved. Press the SECOND button to reset the current value. Press the minute button to toggle auto-countdown mode.
A-Set: Displays the countdown time to be used if you shutdown with auto-countdown activated. This value changes in real-time depending on driving condition. You cannot modify this time
Set: Displays the countdown time to be used in manual mode. Press the MINUTE button to cycle 0-9 minutes, press the SECOND button to toggle from 0-50 seconds in 10 second increments.
Off: Turns the unit off completely.
The unit will perform a countdown when you shut off regardless of what mode you are in, except Off.
When you shut the car off, the display will turn red and begin countdown. At this point, if you are in manual mode, you can press the MINUTE and SECOND buttons to add more time to the countdown.
Auto-mode defaults to 10 seconds. Even after running at periods of high boost I haven't seen the auto-mode indicator go above 39 seconds. It's been the consensus so far that this is not enough time... Stick with manual mode.
Found this on a Google search. Hope this helps
Thread
Thread Starter
Forum
Replies
Last Post
