Goodtimes, when's the next meet!

Here are some fotos.!
Los two Primos...

Nice day.

mazdafiend.

CORRALEEEHHH!!!!







AND HERE IT IS.......

.....the Legend...



S4TII,St.port, 750cc injtrs......




CHEAPER.BETTER.FASTER.

 

Nice pics! That last meet was a hoot. I'm confused on the last one... is that an old pic of Jeremy's TII or a different car?

 

Thats my car before the blizzard of 93 .

 

Whoa... that was what... 15 years ago from this month? I wish I could find pics of "when my cars were young." There were some of the Cheeto on here at some point back when it was factory... it looked really nice. I wish I'd saved them.

 

So, wait? The previous owner gave you pictures of it? That's odd I guess.

 

Man I wish i had pictures of my car when it was original....**** id settle for pictures of the damage caused to my right side pillar and fender area near the hatch...

 

yea id love to see what my little mix looked like original!!!!!!!

 

hey... I'm here in Knoxville and need a drive shaft and oil cooler for my 85 GSL-SE. Any ideas?

 

I was joking guys thats Lou's T2 before we hit the side of a mountain . Dam I miss that car it was the same color but the body was extra clean as you can see .

Psycom I might be able to locate a drive shaft & oil cooler for you let me check and see .

 

I have a fc oil cooler. I'm not sure if fbatman still needs it or not.

 

Any progress on the speaker box?? I may need one for the first gen .

 

Jeremy you bastard. Is that the car I used to see leaving Pellissippi a few years back?

 

I think so .

 

I think I saw it a few times right before it was totaled.

 

DAm on to better news , what do you think about the next meet? . Should it be a dragon meet again ? I'm tring to get the engine bay painted in the first gen so I can hopefully take it to the next meet . Stock 12a + 3 inch drop = Cruiser .......

 

Yep. That was me leavin school.

...the interior was t as pristine as the ex...


That thing hauled ***!

 

moke.

 

man it sucks not having my computer right now!! i can never check the forums except once a week or so! gayness!

 

Oh okay Louis... I used to work at that gas station across the street. I was hoping you'd see my TII sitting out there and stop by.

Next meet could be Dragon, I'm up for that. I gotta get my fan set up before then. It's sorta mounted right now but I've got 3 conflicting wiring diagrams for the components to wire it up with the thermoswitch. I'm gonna dig back into it tomorrow when it warms up. It definitely works, I ran it straight to the battery for a bit and it pushed a lot of air on low.

Hi Jason. How's the FD running?

 

Jeremy, it's basically done. I still want to work on reinforcing where the top and bottom meet. (it's probably fine how it is now) and then just wire it and mount the sub. I already tested it by just holding the sub in the box and so on. it was nice enough for me. If you want one for your fb you could just leave the car up here when it gets warm and it shouldn't take no more than a week. Be warned though. it's expensive. I've got about 200 (probably more but I don't want to know) right now in it not including labor. But by the time I get to your car I'll be better then my box. I'm supposed to do my dad's car sometime. By your's I'll waste less and so on. Pics after I get off the phone.

 

Here it is. It should look way better by the time you guys see it.

 

doesnt look too bad yeti

 

well thanks. The top doesn't look too bad. there was no bubbles or anything.. I can't say that for the bottom. but most of those have been discovered and taken care of.

 

What are you going to use to stiffen it though? I know fiberglass is decent for strength, though I can only imagine the vibration its going to suffer, I know my setup needs to be rethought and repositioned once i make a full box for the space.

 

its running good...tuned her up not to long ago and shes running strong.
im hoping to be able to make it to dgrr...as of now its not looking to good....but i am definatly going to be making a trip there within the next 2 - 3 months.