New Member Section / New Member RX-7 Technical Mar 31, 2026 08:16 PM
From just the little you see of the car, I'd say fixing it, is not feasible. Rot always runs a lot deeper than you can see and with this, you can see a lot. Fixing up even a decent car can easily...
anchaf3
Thread Starter
Classifieds / The NEW RX7 Marketplace Mar 31, 2026 07:31 PM
ibm.rx7
Hey is the HKS downpipe still available ?
MattGold
Thread Starter
Classifieds / The NEW RX7 Marketplace Mar 31, 2026 06:00 PM
Selling a very complete UIM.
Pulled from a 1993 LHD FD3S with 67,xxx that was converting to EV (no, not mine).
Asking $400OBO.
Located in Metro Detroit. Will ship!
MattGold
Thread Starter
Classifieds / The NEW RX7 Marketplace Mar 31, 2026 05:52 PM
Selling a nice Throttle Body WITH TPS sensor still attached.
Pulled from a 1993 LHD FD3S with 67,xxx that was converting to EV (no, not mine).
Asking $450OBO.
Located in Metro Detroit. Will...
1st Generation Specific (1979-1985) / 1st Gen General Discussion Mar 31, 2026 05:42 PM
It would be amazing to get a 3d scan of the front end of the FB
https://cimg7.ibsrv.net/gimg/www.rx7club.com-vbulletin/2000x1183/white_84_gsl_se_003b 99c2fec15eb7175cd98e f8e01fbfbcdf207a.jpg
MattGold
Thread Starter
Classifieds / The NEW RX7 Marketplace Mar 31, 2026 05:36 PM
Selling a COMPLETE set of pedals for a 1992-2002 Mazda RX-7 FD3S.
These were pulled from a 1993 Mazda RX-7 w/ 66,xxx miles.
Thinking about converting from Auto to Manual? Here’s your chance!
...
REW138
Thread Starter
Tech and Performance / General Rotary Tech Support Mar 31, 2026 05:15 PM
dguy
If you're really asking about just 'driving it to a tech' stay out of WOT. Yes, a rich event can cause a stumble, if you're still concerned after that and can't stay out of WOT reduce timing.
speedjunkie
Thread Starter
Tech and Performance / Interior / Exterior / Audio Mar 31, 2026 05:08 PM
Oh I'll be changing the sender regardless if I can't get a good reading out of it. I have it going to the Haltech now and then reading to the digital display, and if it's not consistent I'll be...
fireindc
Thread Starter
Generation Specific / 3rd Generation Specific (1993-2002) Mar 31, 2026 04:17 PM
That is also the direction I'm leaning. Out she goes!
Thanks guys.
Regional Forums / Upcoming Events / SE RX-7 Forum Mar 31, 2026 04:16 PM
FB_Jacob
they seem to be the same size. They are from the same batch same kit I can try lapping two belts, one inner towards the outer and see if that works.