Ford 3.7L V6 fc
#52
Full Member
Thread Starter
#60
JustAnotherFC
iTrader: (2)
Thanks bud.
I'm not planing on racing it but once I get the brakes upgraded and suspension dialed in, I'll
want to know what it's stats are. The car has A/C, music and everything I need in a street car.
I definitely want to know quarter mile times with a primary focus on trap speeds.
I'm not planing on racing it but once I get the brakes upgraded and suspension dialed in, I'll
want to know what it's stats are. The car has A/C, music and everything I need in a street car.
I definitely want to know quarter mile times with a primary focus on trap speeds.
#61
Full Member
Thread Starter
So a quick update. I will be either getting my motor and tranny on Friday or just the motor. Both are $670 with tax or just the motor for $426 with tax. Money may become a little tighter next week.
#63
Full Member
Thread Starter
#65
Full Member
Thread Starter
#70
JustAnotherFC
iTrader: (2)
By the way this was with no exhaust connected after the downpipe!
Now the exhaust is finished as seen in the above pic in post #66.
It's super quiet. Besides a very deep and low base the engine is more quiet then my wife's Toyota
v6 Venza.
However my car does have an aggressive growl on start-up while the cams are doing their thing.
The shifting is rapid and in 6th gear in probably a few hundred feet. "kinda" like a DCT.
I just gotta get the sequential shifter signal right. That's next.
Now the exhaust is finished as seen in the above pic in post #66.
It's super quiet. Besides a very deep and low base the engine is more quiet then my wife's Toyota
v6 Venza.
However my car does have an aggressive growl on start-up while the cams are doing their thing.
The shifting is rapid and in 6th gear in probably a few hundred feet. "kinda" like a DCT.
I just gotta get the sequential shifter signal right. That's next.
#74
Full Member
Thread Starter
New: took the busted valve cover off to check out the cams.
Last edited by 30mpgfc; 12-19-15 at 04:17 PM.
#75
Full Member
Thread Starter
Bought a 2012 mt82 W/64k mi a couple weeks ago for $186 W/tax. The bolt holes all match except for two on the oil pan. The pan looks like a pair of ugly **** so I might have to source a stang/f150 pan. Got an end of the year bonus this week so I'll check my bills and if possible pickup a new valve cover and front+rear main seals.
Last edited by 30mpgfc; 12-30-15 at 11:09 AM. Reason: Picture