Need a bit of help...
Need a bit of help...
Need a bit of help...
I need someone that is mechanically inclined and has preferably worked on cars before... about an hour if your time in the shop... If you have no clue what your doing this is not really the project to learn on... I'll be happy to teach someone on a easier install though...
I have the tranny out of my car and need someone to help me lift it back into place.
It is not impossible to do alone -but a pain when the car is on jackstands... I should have simply pulled the whole engine out...
My shop is right around exit 145 on the GSPW 2 min off the highway... looking to get this done Mon night... I'll be at the shop from about 7pm till it's done. ( should not be long once the tranny is in)
This will be a big "I owe you one" as in I'll give you a hand when you need it/welcome to my shop anytime.
any takers?
-Andrew
TIA
old and new
I need someone that is mechanically inclined and has preferably worked on cars before... about an hour if your time in the shop... If you have no clue what your doing this is not really the project to learn on... I'll be happy to teach someone on a easier install though...
I have the tranny out of my car and need someone to help me lift it back into place.
It is not impossible to do alone -but a pain when the car is on jackstands... I should have simply pulled the whole engine out...
My shop is right around exit 145 on the GSPW 2 min off the highway... looking to get this done Mon night... I'll be at the shop from about 7pm till it's done. ( should not be long once the tranny is in)
This will be a big "I owe you one" as in I'll give you a hand when you need it/welcome to my shop anytime.
any takers?
-Andrew
TIA
old and new

i actually wouldnt mind helping at all but idk how much i can assist you.. if this is like hold this here while i screw this is i can help lol
but seriously if you need help and my help is sufficient let me know.. just give me a call tomorrow 732 887 1025
but seriously if you need help and my help is sufficient let me know.. just give me a call tomorrow 732 887 1025
then test drive!
Last edited by sunburn; Oct 27, 2008 at 02:12 AM.
Trending Topics
went well!
All that is left is the starter, a few wires, add trans fluid and go!
oh and the exhaust...
I'm considering running it open header to the Tues night meet for ***** and giggles
Bennie did a great job... installed the slave cyl and driveshaft himself and helped get the tranny in place... good worker! Thanks Bennie!
All that is left is the starter, a few wires, add trans fluid and go!
oh and the exhaust...
I'm considering running it open header to the Tues night meet for ***** and giggles
Bennie did a great job... installed the slave cyl and driveshaft himself and helped get the tranny in place... good worker! Thanks Bennie!
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM



