Megasquirt DIYPNP bought, built, q's remain

Reply Subscribe

Thread Tools

Search this Thread

Jun 26, 2013 | 06:52 PM

#76

sft3303

Thread Starter

Full Member

Joined: Feb 2012

Posts: 153

Likes: 1

From: Tuscaloosa, AL

So I re-flashed the megasquirt with the 3.1.0 firmware, and faked a 24-1 wheel signal using an arduino to it. The ignition outputs seemed to look good (quick, matching flashes from IGN1 and IGN2 and a toggling flash from WLD) and the guages on tunerstudio looked alright. I'll test it out on the car next time I have the chance, probably will be a while before the car can come down from daily use for that.

But hey, glad I've got this much for now.

Jun 27, 2013 | 09:54 PM

#77

denverstone

Junior Member

Joined: Aug 2012

Posts: 13

Likes: 0

From: North Texas

Quote:

Originally Posted by sft3303

So I re-flashed the megasquirt with the 3.1.0 firmware, and faked a 24-1 wheel signal using an arduino to it. The ignition outputs seemed to look good (quick, matching flashes from IGN1 and IGN2 and a toggling flash from WLD) and the gauges on tunerstudio looked alright. I'll test it out on the car next time I have the chance, probably will be a while before the car can come down from daily use for that.

But hey, glad I've got this much for now.

When you went to 3.1.0 are you getting any errors? I have been getting a lot of errors (communication etc), I can usually clear them and it seems to have no effect on the car.......I need to get the car back to get the error, but I will post when I have the car again.