vrx8

iTrader: (18)

This is PS1K with PnP patch for the FD.

I got the car idling and idle is rock solid. When I try to give it gas, it rev's but stumbling until it hits 2k and RPM's drop.

I have a GM 3 Bar map, I tried uploading the GM 3 Bar calibration to the ps1000 but then the car won'r even start. If i go to the stock calibration the car idles fine.

Any ideas?

C. Ludwig

iTrader: (27)

Ummmm. You need to tune it?

vrx8

iTrader: (18)

Ok sounds good. I thought it was something on the settings or something else other than tuning.

C. Ludwig

iTrader: (27)

It may be. The question is very vague and you've given no information. Post your map.

vrx8

iTrader: (18)

Ok, so I broke my 3bar map sensor . Im back on the OEM Map and got the car idling fine but still drops at 2k, attached is the map im using.

C. Ludwig

iTrader: (27)

Your fuel map is terrible bu there is nothing I see in the settings that would cause the issue. The actual rev limiter is set to 5500. Tha will need to be changed, but it's not causing this issue. I would suspect the fuel map is the problem.

vrx8

iTrader: (18)

Lol, I downloaded that base map form Claudios thread. If the settings are good the is just a matter of fuel and timing.

I was messing with it yesterday and I gave it more gas and it went past 2k, but it drops at 2k and then clears up.

C. Ludwig do you have a base map for ID injectors?

sleeper7

If you're still having issues, probably help you out with transition and drivability issues. Will NOT do a full tune, that's up to you. But getting it to drive, I can help.

vrx8

iTrader: (18)

pm'd

rx72c

iTrader: (8)

what size injectors?

vrx8

iTrader: (18)

Sleeper7 helped me out got everything sorted out.
Im running ID725/2000

C. Ludwig

iTrader: (27)

Was the issue the fuel map?

vrx8

iTrader: (18)

Fuel map and tps was out of range