PS1000 won't rev past 2k
 

This is PS1K with PnP patch for the FD.

I got the car idling and idle is rock solid. When I try to give it gas, it rev's but stumbling until it hits 2k and RPM's drop.

I have a GM 3 Bar map, I tried uploading the GM 3 Bar calibration to the ps1000 but then the car won'r even start. If i go to the stock calibration the car idles fine.

Any ideas?

Ummmm. You need to tune it?

Ok sounds good. I thought it was something on the settings or something else other than tuning.

It may be. The question is very vague and you've given no information. Post your map.

Ok, so I broke my 3bar map sensor :(. Im back on the OEM Map and got the car idling fine but still drops at 2k, attached is the map im using.

Your fuel map is terrible bu there is nothing I see in the settings that would cause the issue. The actual rev limiter is set to 5500. Tha will need to be changed, but it's not causing this issue. I would suspect the fuel map is the problem.

Lol, I downloaded that base map form Claudios thread. If the settings are good the is just a matter of fuel and timing.

I was messing with it yesterday and I gave it more gas and it went past 2k, but it drops at 2k and then clears up.

C. Ludwig do you have a base map for ID injectors?

If you're still having issues, probably help you out with transition and drivability issues. Will NOT do a full tune, that's up to you. But getting it to drive, I can help.

pm'd

what size injectors?

Sleeper7 helped me out got everything sorted out.
Im running ID725/2000

Was the issue the fuel map?

Fuel map and tps was out of range