Haltech PS1000 won't rev past 2k
#1
PS1000 won't rev past 2k
This is PS1K with PnP patch for the FD.
I got the car idling and idle is rock solid. When I try to give it gas, it rev's but stumbling until it hits 2k and RPM's drop.
I have a GM 3 Bar map, I tried uploading the GM 3 Bar calibration to the ps1000 but then the car won'r even start. If i go to the stock calibration the car idles fine.
Any ideas?
I got the car idling and idle is rock solid. When I try to give it gas, it rev's but stumbling until it hits 2k and RPM's drop.
I have a GM 3 Bar map, I tried uploading the GM 3 Bar calibration to the ps1000 but then the car won'r even start. If i go to the stock calibration the car idles fine.
Any ideas?
#7
Lol, I downloaded that base map form Claudios thread. If the settings are good the is just a matter of fuel and timing.
I was messing with it yesterday and I gave it more gas and it went past 2k, but it drops at 2k and then clears up.
C. Ludwig do you have a base map for ID injectors?
I was messing with it yesterday and I gave it more gas and it went past 2k, but it drops at 2k and then clears up.
C. Ludwig do you have a base map for ID injectors?
Trending Topics
#8
Rotary Enthusiast
Join Date: Aug 2006
Location: Melbourne FL/San Antonio TX/Okinawa Japan
Posts: 1,216
Likes: 0
Received 10 Likes
on
10 Posts
If you're still having issues, probably help you out with transition and drivability issues. Will NOT do a full tune, that's up to you. But getting it to drive, I can help.
Thread
Thread Starter
Forum
Replies
Last Post