Broke_A_Baller

iTrader: (26)

Thanks Obama!

RENESISFD

iTrader: (13)

Ok, this has gone on long enough. All involved just drop it.

3rdgensleeper

iTrader: (10)

Thank you RENESISFD

DreamInRotary

iTrader: (49)

Well that was entertaining...I was finally able to go and see where all of that stemmed from - good times!

Anyways, any updates on this beast?

3rdgensleeper

iTrader: (10)

I should have some updates in the upcoming week I was traveling for work this past two weeks so I couldn't get much done

Broke_A_Baller

iTrader: (26)

shawnm565

iTrader: (3)

Hopefully Robert & I can get both our builds ready for this season asap!

BLACK MAMBA

iTrader: (58)

R-R-Rx7

iTrader: (24)

Whole thing aside you have a nice build thread going on and i wish you to accomplish your goals with the least problems possible

3rdgensleeper

iTrader: (10)

Thanks man, that's cool of you to say.

Ruler_Mark

iTrader: (16)

When this thing is done and before I build my motor we need to line em up. Both are running the same turbo. Would be an ultimate comparison.

3rdgensleeper

iTrader: (10)

nice! so you are running a stock port motor with the s475? what hot side are you using, the T4 0r T6?

I just installed my new compressor into my garage so i will be back in action now, the last one took a crap on me randomly. sooooo i went with a larger more powerful one 80Gal, 7.5hp, 30CFM compared to my old 60gal,6hp,12cfm…. i am loving it so far I can not outrun it even while running my blasting cabinet.

DreamInRotary

iTrader: (49)

Hey man, it was super nice meeting you and the other guys today - this thing should be an absolute 13bad-*** when it's done for sure!

needspartsnow

iTrader: (10)

ok, we've been patient enough...updates?

3rdgensleeper

iTrader: (10)

Hey sorry for the lack of updates here, lots going on both car world and in my life hahaha.

My rotating assembly should be back very soon so motor will be built in the near future.
interior has been fully gutted and cleaned up, about to lizard skin the exposed metal.
I am going to hold off on a fuel cell this year and just run a CJ hanger in the stock tank to feed my SP1200 surge tank.

parts I will need to order are-

2x ID1300
8x ID1700
4x Walboro pumps
fuel line
2x turbosmart WGs
turbosmart FPR
misc tubing for dp and mp as well as IC piping and coolant system.

I hope to have a lot of this done within the next few months, but with my work schedule ( I travel globally) it takes a ton of my time. Maybe I will just quit and build racecars all day

Wish it was a better update, more to come hopefully soon.

Broke_A_Baller

iTrader: (26)

That's going to get 4MPG.

:-D

3rdgensleeper

iTrader: (10)

it will be a very enjoyable 4MPG lol

schaft

iTrader: (1)

Sub'd