porting 89 + wastegate?
04-25-02, 05:33 PM
#1
Rotary Enthusiast
Thread Starter
Join Date: Mar 2001
Location: orlando ,fl
Posts: 790
Likes: 0
Received 0 Likes
on
0 Posts
porting 89 + wastegate?
on reted site they show the 89 wastegate with the flapper over the holes .....are they two holes ? and how much can the holes be ported ?
04-25-02, 06:12 PM
#3
I wish I was driving!
The problem trying to port:
The actuator arm on the Waste gate flapper door hits against the botoom of the housing. I dunno how you should get it off, but it can be bent or welded easily, I know
The actuator arm on the Waste gate flapper door hits against the botoom of the housing. I dunno how you should get it off, but it can be bent or welded easily, I know
04-25-02, 06:14 PM
#4
I wish I was driving!
And the view when you get the flapper door all the way open:
Who do you love?
These holes can be ported to the edge of the flapper doors if required.
If you want any more pics (again performed by my shitty webcam, just post here and tell me you love me)
Sean Cathcart
This is not my turbo, but instead a spare one I dissassembled in my basement.
Mine is ported and on my car. I will port this one and take webcam pics IYW.
Who do you love?
These holes can be ported to the edge of the flapper doors if required.
If you want any more pics (again performed by my shitty webcam, just post here and tell me you love me)
Sean Cathcart
This is not my turbo, but instead a spare one I dissassembled in my basement.
Mine is ported and on my car. I will port this one and take webcam pics IYW.
04-25-02, 09:00 PM
#5
Senior Member
Join Date: Apr 2002
Location: Waco, Tx
Posts: 250
Likes: 0
Received 0 Likes
on
0 Posts
so could you port between the doors? like the pics shown in red? i dont have a rx7 so I cant see what the actual wastegate looks like other than pics but am absorbing all i can.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Shainiac
Single Turbo RX-7's
12
07-17-19 02:20 PM