I followed the wiring for the limiter light won’t turn on I have the ground connected to the hand brake, wires it all up, cut the brown wire nothing happened put it back cut the grey wire nothing happened the light won’t turn on at all what do I got to do.

 

Did you buy a real one? What diagram did you follow and where and how did you tap the wires

 

Just making sure you’re not using the bee r rev limiter with a power fc. I had to disconnect my bee r limiter once I installed the power fc since the bee r would cut ignition randomly, looked to be a known issue.

just a note since you didn’t mention what ecu you’re using. Worked great with a rtek/stock ecu though.

 

stock 86 ecu had my friend follow the turbo s4 write up on it in here

 

had a buddy do it he followed the write up on here for the s4 turbo that’s in the forum

 

Alright so theres a chance it was done wrong. Post pictures of the install and where did the bee r come from. How do you know its a real bee r

 

came from the guy I got it from it worked in his old car he said but it’s been sitting in my tool box I’ll pull back the plate some time next week light won’t even turn on. Where else can I ground it besides the handbrake?

 

Do nothing. Just post the pictures of the install. If your friend did it wrong then let's just fix it. Odds are its either fake or installed wrong. The red light only comes on when its actively working. Its not just on with power.

Post the link to the write up as well

 

haven’t had time to grab photos. But we went off of tbis for the most part https://www.rx7club.com/2nd-generati...s4-tii-812976/