Race Car Tech Discuss anything related to road racing and auto X.

What type of Oil Temps are you seeing?

Thread Tools
 
Search this Thread
 
Old 10-27-08, 12:22 PM
  #26  
Searching for 10th's

iTrader: (11)
 
jkstill's Avatar
 
Join Date: May 2002
Location: Portland OR
Posts: 2,247
Received 29 Likes on 18 Posts
Originally Posted by Black91n/a
Ambient conditions have a HUGE impact on cooling though. Try that at altitude in 110 degree dry heat and you may have very different results. Not only would it have been cool, but it was probably reasonably humid, no?
How about an autox in much warmer conditons?

90f+

Run flat out for 1 minute and stop.

Temp for oil and coolant - both 210f.
Old 11-08-08, 12:08 AM
  #27  
New Turbo time!

iTrader: (2)
 
Zell's Avatar
 
Join Date: Sep 2005
Location: New Zealand
Posts: 91
Likes: 0
Received 0 Likes on 0 Posts
Hey Guys,

I just installed some defi gauges after my rebuild and have been watching the gauges now the oil temp sensor in on the oil filter pedestal, i dont have previous readings to compare them with but im get around 190F on the oil just crusing around but it goes up when you get on the freeway i pulled off when it got to 230F and then it drops back to the crusing figure, if i stop at traffic lights or park up it will drop to 185F now i had the oil cooler flushed and im getting very good oil presure so i presume the thermostat in the cooler must be opening as if it was blocked the oil presure would be very low correct? Im currently running in the motor if that makes a difference and the timing has be retarded. The oil temp really only goes up on the freeway and i dont have the factory under tray it never came with the car and the orginal motor popped a couple of Apex seals.

Water temp also goes up a little on the freeway but i have a large electric fan running all the time with a Koyo radiator. Oil is 15w40 Pennziol Mineral which im changing shortly to a 15w50 Mobil Mineral. This may have a small effect im told as the oil gets very contaminated when breaking in a new motor

Im a bit concerned as im not sure what the temps will get to when i give the car a bit of **** but because im running it in i cant tell at this point, im looking into getting a vented bonnet but i would be very surprised if this is the cause, any ideas would be great guys.

Cheers

Last edited by Zell; 11-08-08 at 12:20 AM.
Old 11-08-08, 12:14 AM
  #28  
Lives on the Forum

 
Black91n/a's Avatar
 
Join Date: Sep 2003
Location: BC, Canada
Posts: 5,707
Likes: 0
Received 4 Likes on 4 Posts
Originally Posted by Zell
Hey Guys,

I just installed some defi gauges after my rebuild and have been watching the gauges now the oil temp sensor in on the oil filter pedestal, i dont have previous readings to compare them with but im get around 190F on the oil just crusing around but it goes up when you get on the freeway i pulled off when it got to 230F and then it drops back to the crusing figure, now i had the oil cooler flushed and im getting very good oil presure so i presume the thermostat in the cooler must be opening as if it was blocked the oil presure would be very low correct? Im currently running in the motor if that makes a difference and the timing has be retarded. Water temp also goes up a little on the freeway but i have a large electric fan running all the time with a Koyo radiator. Oil is 15w40 Pennziol Mineral which im changing shortly to a 15w50 Mobil Mineral.

Im a bit concerned as im not sure what the temps will get to when i give the car a bit of **** but because im running it in i cant tell at this point, im looking into getting a vented bonnet but i would be very surprised if this is the cause, any ideas would be great guys.

Cheers
The oil pressure is regulated after the oil cooler, so unless you've got a huge restriction then you won't see any differences. If the thermostat is open and bypassing the cooler, you won't see any difference, as it'll be giving a lower pressure drop, so supplying the pressure relief valve with higher pressure, bleeding more off.
Old 11-10-08, 10:11 PM
  #29  
Taz
Full Member

iTrader: (1)
 
Taz's Avatar
 
Join Date: Mar 2001
Location: Ponce PR
Posts: 146
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by Zell
Hey Guys,

..........up on the freeway and i dont have the factory under tray it never came with the car and the orginal motor popped a couple of Apex seals................

Cheers
Hi,
For fd's the factory undertray is a functional element in the cooling system. If your car is w/out it, the air will skip the radiator and just flow under the car. Once intalled, make sure it makes a tight seal against the radiator, especially at the rear of the tray, where a flap that seals against the full width of the radiator will sag down with time.
Good luck
Old 11-11-08, 11:28 AM
  #30  
Moderator

iTrader: (3)
 
j9fd3s's Avatar
 
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,832
Received 2,601 Likes on 1,846 Posts
Originally Posted by Zell
Hey Guys,

I just installed some defi gauges after my rebuild and have been watching the gauges now the oil temp sensor in on the oil filter pedestal, i dont have previous readings to compare them with but im get around 190F on the oil just crusing around but it goes up when you get on the freeway i pulled off when it got to 230F and then it drops back to the crusing figure, if i stop at traffic lights or park up it will drop to 185F now i had the oil cooler flushed and im getting very good oil presure so i presume the thermostat in the cooler must be opening as if it was blocked the oil presure would be very low correct? Im currently running in the motor if that makes a difference and the timing has be retarded. The oil temp really only goes up on the freeway and i dont have the factory under tray it never came with the car and the orginal motor popped a couple of Apex seals.

Water temp also goes up a little on the freeway but i have a large electric fan running all the time with a Koyo radiator. Oil is 15w40 Pennziol Mineral which im changing shortly to a 15w50 Mobil Mineral. This may have a small effect im told as the oil gets very contaminated when breaking in a new motor

Im a bit concerned as im not sure what the temps will get to when i give the car a bit of **** but because im running it in i cant tell at this point, im looking into getting a vented bonnet but i would be very surprised if this is the cause, any ideas would be great guys.

Cheers
possible that the thermostat isn't happy in the oil cooler.
Old 11-11-08, 12:28 PM
  #31  
Old [Sch|F]ool

 
peejay's Avatar
 
Join Date: May 2001
Location: Cleveland, Ohio, USA
Posts: 12,506
Received 416 Likes on 296 Posts
Originally Posted by jkstill
How about an autox in much warmer conditons?

90f+

Run flat out for 1 minute and stop.

Temp for oil and coolant - both 210f.

Don't forget that you're running flat out with minimal airflow relative to an open track.

Rallycross is worse - full throttle and you're only slogging along at 30-45mph and half the time you're sideways anyway. I've seen 220+ in the summertime on a 30 second course.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
FD7KiD
3rd Generation Specific (1993-2002)
15
02-26-21 10:12 PM
stickmantijuana
Microtech
30
04-23-16 06:37 PM
Snoopy FD
Build Threads
25
12-08-15 01:45 PM
FD7KiD
Single Turbo RX-7's
1
08-17-15 11:50 PM



Quick Reply: What type of Oil Temps are you seeing?



All times are GMT -5. The time now is 07:17 PM.