Tegheim - Home made 4 Rotor Wolvo project
#80
Senior Member
Thread Starter
This is how it could look when I'm measure an 20B-shaft
Have only rough-turned the both sides to 46mm, will drill the oil-chanel and so on before I do the fine-cut.
Have only rough-turned the both sides to 46mm, will drill the oil-chanel and so on before I do the fine-cut.
#85
Junior Member
Join Date: Jun 2003
Location: New Zealand
Posts: 48
Likes: 0
Received 0 Likes
on
0 Posts
Very nice cnc work! I run mastercam too but not at your level!
Did you make a dummy shaft out of some cheap aluminium or mild steel to test the programs first? Or just go straight to the expensive stuff?!?!
Did you make a dummy shaft out of some cheap aluminium or mild steel to test the programs first? Or just go straight to the expensive stuff?!?!
#88
Senior Member
Thread Starter
Thanks!
Have started on the two loose ends. And as I did with the main-shaft, I spared a few bucks taking a smaller material, but then I have to turn the centre from an excenter from start. But why not All you can save in money you can have more fun fore
#98
Senior Member
Thread Starter