Rx7 restore
02-24-21, 03:51 PM
#1
Junior Member
Thread Starter
Rx7 restore
Just jumped wire connector that primes fuel system. An did not get anything from pump. What could be the problem? It's on a rx7 mazda turbo2 1.3 L
02-24-21, 07:17 PM
#2
from the thread title, "restore", my first question is was the car previously running and suddenly stopped, or was it sitting for a while and you're trying to get it running now?
either way, check if you get power at the pump while trying to crank the engine. if you do, then check the pump itself.
https://www.rx7club.com/2nd-gen-gene...rning-1138673/
either way, check if you get power at the pump while trying to crank the engine. if you do, then check the pump itself.
https://www.rx7club.com/2nd-gen-gene...rning-1138673/
02-24-21, 08:14 PM
#3
Junior Member
Thread Starter
Rx7 restore
Thanks for reply found problem it was in fuel pump relay. Car set for about 30 years but only has 21,000 miles on it just trying to get it back on road again. Tips on best way to clean fuel lines from bad fuel in it. I've clean fuel tank getting ready to purge fuel lines for leaks.
02-24-21, 10:10 PM
#4
https://www.aaroncake.net/rx-7/unstore.htm
21,000 miles? that's pretty sweet! congrats!
good luck and post some photos when you get a chance.
21,000 miles? that's pretty sweet! congrats!
good luck and post some photos when you get a chance.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post