Haltech e8 problems
#1
Rotary Enthusiast
Thread Starter
iTrader: (3)
Join Date: Jan 2007
Location: st. louis
Posts: 1,000
Likes: 0
Received 0 Likes
on
0 Posts
e8 problems
I am pretty fed up with dealing with my haltech install. Since there is no one close to me that can do the haltech install i am wondering if there is some place i can send my harness to be made correctly. Also, is there a place besides haltech itself that i can send my e8 to make sure that it is working correctly. Thanks
#4
Rotary Enthusiast
Thread Starter
iTrader: (3)
Join Date: Jan 2007
Location: st. louis
Posts: 1,000
Likes: 0
Received 0 Likes
on
0 Posts
the car is difficult to start. I have gotten it to idle and checked the timing and the L1 coil is flashing wtih the yellow marker. The car barely revs, when i do rev it a bit and release the gas it dies almost immediately. Also, when i rev it it belches large quantities of smoke out of the tail pipe. The engine is a 13bt HBP with an a-spec 500r turbo. I emailed BDC, the guy who did the port job for help on the map but i have yet to get a response.
thanks for the help
thanks for the help
#7
Lives on the Forum
Find a competent installer / tuner.
The fault is not with the Haltech.
I just put down 240 at the wheels on a Dyna Pack.
Stock turbo, 11psi
Stock TMIC
Stock fuel pump - oops
*87* octane
Haltech E8
It does wonders when you let an expert do the job.
-Ted
The fault is not with the Haltech.
I just put down 240 at the wheels on a Dyna Pack.
Stock turbo, 11psi
Stock TMIC
Stock fuel pump - oops
*87* octane
Haltech E8
It does wonders when you let an expert do the job.
-Ted
Trending Topics
#8
Rotary Enthusiast
Thread Starter
iTrader: (3)
Join Date: Jan 2007
Location: st. louis
Posts: 1,000
Likes: 0
Received 0 Likes
on
0 Posts
i am realizing that wiring/tuning is not my forte. i just want to get this bloody thing working so i can take it to get it tuned. I have not found a good haltech guy in my town. I can send my harness away but that is not my favorite option. I am fairly confident that my harness is right. I guess we will find out once i get my new basemap from my engine porter.
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
1st Generation Specific (1979-1985)
7
09-18-15 07:13 PM