New engine wont start, 0% injector duty while cranking???
04-19-19, 03:56 PM
#1
Full Member
Thread Starter
Join Date: Oct 2005
Location: England
Posts: 157
Likes: 0
Received 0 Likes
on
0 Posts
New engine wont start, 0% injector duty while cranking???
evening all
I have just rebuilt my FD3 engine and converted to single turbo, I am still using the APexi PFC that i was using before it blew a tip when running the twins. I have put bigger injectors and modified the loom accordingly. The commander is displaying revs, vacume, TPS and temps and I have spark but it just wont fire. I have fuel pressure.
I am baffled. I understand that if i have spark the white crank angle sensor must be working?
Any suggestions gratefully received....
I have just rebuilt my FD3 engine and converted to single turbo, I am still using the APexi PFC that i was using before it blew a tip when running the twins. I have put bigger injectors and modified the loom accordingly. The commander is displaying revs, vacume, TPS and temps and I have spark but it just wont fire. I have fuel pressure.
I am baffled. I understand that if i have spark the white crank angle sensor must be working?
Any suggestions gratefully received....
04-20-19, 02:28 AM
#3
Full Member
Thread Starter
Join Date: Oct 2005
Location: England
Posts: 157
Likes: 0
Received 0 Likes
on
0 Posts
I have had a run in map put on my PFC and also tried another Ecu but its exactly the same
evening all
I have just rebuilt my FD3 engine and converted to single turbo, I am still using the APexi PFC that i was using before it blew a tip when running the twins. I have put bigger injectors and modified the loom accordingly. The commander is displaying revs, vacume, TPS and temps and I have spark but it just wont fire. I have fuel pressure.
I am baffled. I understand that if i have spark the white crank angle sensor must be working?
Any suggestions gratefully received....
I have just rebuilt my FD3 engine and converted to single turbo, I am still using the APexi PFC that i was using before it blew a tip when running the twins. I have put bigger injectors and modified the loom accordingly. The commander is displaying revs, vacume, TPS and temps and I have spark but it just wont fire. I have fuel pressure.
I am baffled. I understand that if i have spark the white crank angle sensor must be working?
Any suggestions gratefully received....
Thread
Thread Starter
Forum
Replies
Last Post
antnicuk
Adaptronic Engine Mgmt - AUS
1
04-29-19 02:23 PM
jetlude
Single Turbo RX-7's
9
03-16-17 04:47 PM
jetlude
Single Turbo RX-7's
3
04-11-09 08:23 PM