When i try starting my fd it wont start if i turn the key normally. I have to have it in the off position, and then crank it really fast and sometimes it still wont even try to crank itll just make a little noise. Any ideas?

 

Check the ground behind the A/C compressor to the frame. If not you need a starter.

 

Have you checked or bypass the alarm relay yet?

Sent from my iPhone using RX7Club

 

Alright I'll check that thanks!

No I haven't tried that! Where would I find the alarm relay? How would I bypass it?

Also another question, would a bad battery cause my starting problem? I'm asking because its reading around 11.5v after sitting for a while and when it's cold (or been sitting a while) and that's when I'm having the problem with the click click start. But when its warm it doesn't seem to have that issue, and the batteries reading in the 12's after a drive for a while. So would that be my issue? If it's not the alarm, and if it's not the battery it would have to be the starter solenoid/starter correct?

 

What you need to keep in mind is your CCA not only your volts. You can have a battery with good volts but poor CCA. I will post pics on the reply to add a jumper.

Sent from my iPhone using RX7Club

 

Sent from my iPhone using RX7Club

 

Its a 450cca battery. Isnt 11s low voltage though also? Would a bad battery cause the issue im having? And alright cool

 

Which ones do i use? And by the way i have a viper alarm too

 

Sorry Xmas & all. This is how I did mine so I can plug the relay back in.





Sent from my iPhone using RX7Club

 

Maybe this will you, even if it doesn't you have 1 more thing done on your check list.

https://www.rx7club.com/3rd-generati...41/?styleid=12

Best of luck Chris.

Sent from my iPhone using RX7Club

 

Thanks! I put a new battery in and its good now! Thanks for your advice ill do that anyways

 

Forgot about that f¥€%#g relay. Oh the fun of having a virgin 7 :{