FD doesn't start when turning key slow?
#1
Full Member
Thread Starter
FD doesn't start when turning key slow?
When i try starting my fd it wont start if i turn the key normally. I have to have it in the off position, and then crank it really fast and sometimes it still wont even try to crank itll just make a little noise. Any ideas?
#4
Full Member
Thread Starter
Also another question, would a bad battery cause my starting problem? I'm asking because its reading around 11.5v after sitting for a while and when it's cold (or been sitting a while) and that's when I'm having the problem with the click click start. But when its warm it doesn't seem to have that issue, and the batteries reading in the 12's after a drive for a while. So would that be my issue? If it's not the alarm, and if it's not the battery it would have to be the starter solenoid/starter correct?
#5
Rotating Performance.
iTrader: (42)
Join Date: Jul 2005
Location: Miami, FL.
Posts: 1,820
Likes: 0
Received 0 Likes
on
0 Posts
What you need to keep in mind is your CCA not only your volts. You can have a battery with good volts but poor CCA. I will post pics on the reply to add a jumper.
Sent from my iPhone using RX7Club
Sent from my iPhone using RX7Club
#7
Full Member
Thread Starter
Its a 450cca battery. Isnt 11s low voltage though also? Would a bad battery cause the issue im having? And alright cool
Trending Topics
#10
Rotating Performance.
iTrader: (42)
Join Date: Jul 2005
Location: Miami, FL.
Posts: 1,820
Likes: 0
Received 0 Likes
on
0 Posts
Maybe this will you, even if it doesn't you have 1 more thing done on your check list.
https://www.rx7club.com/3rd-generati...41/?styleid=12
Best of luck Chris.
Sent from my iPhone using RX7Club
https://www.rx7club.com/3rd-generati...41/?styleid=12
Best of luck Chris.
Sent from my iPhone using RX7Club
Thread
Thread Starter
Forum
Replies
Last Post
The Shaolin
2nd Generation Specific (1986-1992)
9
09-14-15 07:50 PM
Frisky Arab
2nd Generation Specific (1986-1992)
13
08-18-15 05:30 PM