Power Steering Banjo Bolt Size?
#3
Searching for 10th's
iTrader: (11)
Best bet is to take it to a some place that does hydraulic lines.
I had Oil Filter Service build a line for my FD - I looked for the receipt (with part#) but can't locate it.
If you can get the measurements of the fitting, give these guys a call.
I had Oil Filter Service build a line for my FD - I looked for the receipt (with part#) but can't locate it.
If you can get the measurements of the fitting, give these guys a call.
#4
RX-7 Bad Ass
iTrader: (55)
Just went out to the garage and checked, my pump is off the car while I'm upgrading the intercooler
It's 14mm x 1.5. Don't know if you need the length of it, if you're doing AN fittings just get a 14mm x 1.5 banjo and you should be in good shape.
Dale
It's 14mm x 1.5. Don't know if you need the length of it, if you're doing AN fittings just get a 14mm x 1.5 banjo and you should be in good shape.
Dale
#6
Senior Member
iTrader: (8)
Looks like I might need to do the same as well. One question, my P/S pump came with these lines. Its orginally from a Jspec motor. From a few threads Its suppose to be a banjo bolt on both sides of the lines? Also my rack is just a open hole it looks like, anyone know what size the fitting is for the rack side?
Thread
Thread Starter
Forum
Replies
Last Post
LunchboxCritter
2nd Generation Specific (1986-1992)
15
01-03-16 04:11 PM
Frisky Arab
2nd Generation Specific (1986-1992)
13
08-18-15 05:30 PM