Power Steering Banjo Bolt Size?
Power Steering Banjo Bolt Size?
I'm making a line for my power steering to steering rack but I don't know what size adapter i'll need for the Actual power steering unit. Does anyone know what size it is? Thanks much in advance guys!
- Ap
- Ap
Best bet is to take it to a some place that does hydraulic lines.
I had Oil Filter Service build a line for my FD - I looked for the receipt (with part#) but can't locate it.
If you can get the measurements of the fitting, give these guys a call.
I had Oil Filter Service build a line for my FD - I looked for the receipt (with part#) but can't locate it.
If you can get the measurements of the fitting, give these guys a call.
Just went out to the garage and checked, my pump is off the car while I'm upgrading the intercooler 
It's 14mm x 1.5. Don't know if you need the length of it, if you're doing AN fittings just get a 14mm x 1.5 banjo and you should be in good shape.
Dale
It's 14mm x 1.5. Don't know if you need the length of it, if you're doing AN fittings just get a 14mm x 1.5 banjo and you should be in good shape.
Dale
Looks like I might need to do the same as well. One question, my P/S pump came with these lines. Its orginally from a Jspec motor. From a few threads Its suppose to be a banjo bolt on both sides of the lines? Also my rack is just a open hole it looks like, anyone know what size the fitting is for the rack side?
Thread
Thread Starter
Forum
Replies
Last Post
LunchboxCritter
2nd Generation Specific (1986-1992)
15
Jan 3, 2016 04:11 PM
Frisky Arab
2nd Generation Specific (1986-1992)
13
Aug 18, 2015 05:30 PM
