Helppppp
#1
Full Member
Thread Starter
Join Date: Apr 2001
Location: DC Metro
Posts: 131
Likes: 0
Received 0 Likes
on
0 Posts
Helppppp
Hey guys !! BIGG problem here
I just put my UMI & Throttle Body back on ( it was getting polished ) and it seems like I have some problem. It's been about two months since i started my car..and today after UMI....i started my engine and it seems like my RPM isn't going down. It stays at 3K ...Can someone please help me ?? I already checked all my hoses and changed some of the selonoids..throttle cable is fine..
Thanks
I just put my UMI & Throttle Body back on ( it was getting polished ) and it seems like I have some problem. It's been about two months since i started my car..and today after UMI....i started my engine and it seems like my RPM isn't going down. It stays at 3K ...Can someone please help me ?? I already checked all my hoses and changed some of the selonoids..throttle cable is fine..
Thanks
#2
What's your point ?
Join Date: Feb 2001
Location: Gainesville, Fla.
Posts: 3,573
Likes: 0
Received 0 Likes
on
0 Posts
High idle
Since you removed it and sent it out to be polished....it's possible some of the settings were moved while polishing and if not marked at removal then you would never know they aren't in the right place.....could also be off a different car (if they were switched by accident) and you wouldn't know that either. Jack
#4
Hamado things my way!
Join Date: Oct 2001
Location: Pensacola, Florida
Posts: 1,245
Likes: 0
Received 0 Likes
on
0 Posts
I would look toward your throttle position sensor. Look up the test in the service manual. I had a friend who did the hose job, and for some reason, he took the TPS out of the throttle body. His car was doing similar things. Make sure that is in spec, and also check your AWS. If the AWS was stuck on it would give the same results.
Thread
Thread Starter
Forum
Replies
Last Post
MRomano
3rd Generation Specific (1993-2002)
2
04-01-06 04:34 PM