Zer0 Cylinder

alright, all you rx7 electronic experts help me out here...hint icemark =]

wipers are stuck on, turning the switch has NO effect....replaced whole switch assembly with another....it worked for about 2 mins...then same thing

the only way to cut the wipers off is pull the fuse, put it back in.....they continue to run.

what can i do?

Digi7ech

iTrader: (1)

Sounds like you have some bad juice going to it.

A dumbass mechanic fried my wiper switch by putting a charger on the battery and amping it past 18volts.

Blew a few interior fuses as well.

I wouldcheck all fuse s and maybe check the voltage going to the pins. Icemark would probably know for sure though.

Zer0 Cylinder

thanks, yea that guy has each series + model's electrical system memorized

Zer0 Cylinder

save me icemarkkkkkk

Maxthe7man

This happened to me as well, The relay contacts arced together, my car had been sittin awhile, and the wiper mechanism was rather stiff, which I think put excessive load on the relay and arced it, I tapped the **** of the wiper switch with a butt of a screwdriver to stop the wipers, and lubed the wiper mechanism, it never happened again, hope that helps you out..Max

Zer0 Cylinder

lubed it with what?

Icemark

probably bad switch or bad wiper motor (the position sensor in the motor specficly.

Did you put in a rebuilt or new switch? or another junkyard one?

Mike86

most likely some lubricant

Zer0 Cylinder

the switch was one from a parts car i had.....it worked for a couple of minutes...

Icemark

try swapping the wiper motors

Zer0 Cylinder

before i go and yank out the manual, how accessible are they?