RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   2nd Generation Specific (1986-1992) (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/)
-   -   Wipers stuck on (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/wipers-stuck-262347/)

Zer0 Cylinder 01-19-04 06:27 PM

Wipers stuck on
 
alright, all you rx7 electronic experts help me out here...hint icemark =]

wipers are stuck on, turning the switch has NO effect....replaced whole switch assembly with another....it worked for about 2 mins...then same thing

the only way to cut the wipers off is pull the fuse, put it back in.....they continue to run.

what can i do?

Digi7ech 01-19-04 07:42 PM

Sounds like you have some bad juice going to it.

A dumbass mechanic fried my wiper switch by putting a charger on the battery and amping it past 18volts.

Blew a few interior fuses as well.

I wouldcheck all fuse s and maybe check the voltage going to the pins. Icemark would probably know for sure though.

Zer0 Cylinder 01-19-04 07:48 PM

thanks, yea that guy has each series + model's electrical system memorized

Zer0 Cylinder 01-19-04 08:42 PM

save me icemarkkkkkk

Maxthe7man 01-19-04 08:48 PM

This happened to me as well, The relay contacts arced together, my car had been sittin awhile, and the wiper mechanism was rather stiff, which I think put excessive load on the relay and arced it, I tapped the knob of the wiper switch with a butt of a screwdriver to stop the wipers, and lubed the wiper mechanism, it never happened again, hope that helps you out..Max

Zer0 Cylinder 01-19-04 08:51 PM

lubed it with what?

Icemark 01-19-04 10:11 PM

probably bad switch or bad wiper motor (the position sensor in the motor specficly.

Did you put in a rebuilt or new switch? or another junkyard one?

Mike86 01-19-04 10:23 PM


Originally posted by Zer0 Cylinder
lubed it with what?
most likely some lubricant :D

Zer0 Cylinder 01-20-04 07:36 PM


Originally posted by Icemark
probably bad switch or bad wiper motor (the position sensor in the motor specficly.

Did you put in a rebuilt or new switch? or another junkyard one?

the switch was one from a parts car i had.....it worked for a couple of minutes...

Icemark 01-20-04 07:38 PM

try swapping the wiper motors

Zer0 Cylinder 01-20-04 07:40 PM

before i go and yank out the manual, how accessible are they?


All times are GMT -5. The time now is 05:06 PM.


© 2024 MH Sub I, LLC dba Internet Brands