Ok i have a couple questions about my turbo swap im about to start, hope someone can help.

1. ok so i have my swap that i ordered from tigarimports, before i install it i would like to perfomed a compression test and figure out if its actually any good?? is this possible??

2. Is there anything else i should do before installing my swap?

3. I havent received my exhaust system yet so would it be safe to run the car without any exhaust at all?

 

bolt on bell with starter add power and thats bout it

 

Mount a bellhousing to the engine, install starter, add power.

-Read this thread: https://www.rx7club.com/2nd-gen-archive-72/s4-na-turbo-swap-details-813825/
-Think about cleaning up and possibly painting the engine bay
-Replacing the front suspension bushings is much easier when you can drop the whole subframe at once, and dropping the subframe is much easier with the engine out
-Go over all your wiring


No exhaust at all? I wouldn't do it for more than a few seconds (considering the exhaust outlet of the turbo is aimed at the firewall), Just a downpipe is good to go though (functionally at least, your hearing will suffer).