steering rack swap question
Unplug the PS computer, it's under the dash, on the left side above the clutch lever; you might as well just pull the whole computer since you have the Manual rack.
Joined: Sep 2005
Posts: 25,581
Likes: 136
From: Smiths Falls.(near Ottawa!.Mapquest IT!)
Pull the Power steering ECU out.
since you disconnected the PS pump,you have a Sender that says "'hey,something is wrong here".It goes to the PS Ecu.
disconnecting the PS ecu will remove the Beep.
since you disconnected the PS pump,you have a Sender that says "'hey,something is wrong here".It goes to the PS Ecu.
disconnecting the PS ecu will remove the Beep.
Thread Starter
Joined: Mar 2009
Posts: 1,385
Likes: 0
From: Whitby
i looked in the fsm under electrical and power steering but no luck..... it looks like there are two ecu's there i dont know which one is the power steering one
Trending Topics
Can Post Only in New Member Section
iTrader: (2)
Joined: Jul 2004
Posts: 930
Likes: 0
From: Calgary, Canada
the beep will still continue
i just figured this out myself.
when i pulled my PS computer i got 2 beep, pause repeat. 2 beep means the PS is not functioning.
this beeping comes from the CPU. you have to replace the CPU with one from a GX model.
i just figured this out myself.
when i pulled my PS computer i got 2 beep, pause repeat. 2 beep means the PS is not functioning.
this beeping comes from the CPU. you have to replace the CPU with one from a GX model.
Thread
Thread Starter
Forum
Replies
Last Post
NCross
1st Generation Specific (1979-1985)
9
Aug 29, 2015 01:55 PM
JIMMY54
1st Generation Specific (1979-1985)
2
Aug 12, 2015 05:40 PM
