Build progress 2.0
#81
Right near Malloy
iTrader: (28)
Join Date: Dec 1999
Location: Behind a workbench, repairing FC Electronics.
Posts: 7,840
Received 509 Likes
on
345 Posts
Subscribed... I fucked my car up the same way:
https://www.rx7club.com/lounge-192/scrape-crunch-ffffuuuuuuu-body-work-888791/
Still trying to figure this bodywork stuff out.
https://www.rx7club.com/lounge-192/scrape-crunch-ffffuuuuuuu-body-work-888791/
Still trying to figure this bodywork stuff out.
#82
2/24/2010:
un-masked the car finally, installed rear wheel to check wheel fitment after flaring the 1/4's....1" wider lips will sit flush with the outer edge of the 1/4 panel...should be perfect.
the paint will be wet sanded, and the entire car will be buffed in early april....so yes i know there is orange peel, and dust in the paint...its normal.
un-masked the car finally, installed rear wheel to check wheel fitment after flaring the 1/4's....1" wider lips will sit flush with the outer edge of the 1/4 panel...should be perfect.
the paint will be wet sanded, and the entire car will be buffed in early april....so yes i know there is orange peel, and dust in the paint...its normal.
#84
well rested,buffet o food
The truth comes out when the clear goes on.
You did a really good job on those pulls.
Car looks great, man.
Deffinately gonna inspire quite a few people.
Edit: I deffinately can't spell definitely.
John ny
You did a really good job on those pulls.
Car looks great, man.
Deffinately gonna inspire quite a few people.
Edit: I deffinately can't spell definitely.
John ny
#98
the original wastegate port was 13mm, now it is 32mm....so i needed a 34mm flapper door:
the flapper door is stainless steel, 34mm OD, and has a 1mm deep section that is 31.5mm OD, so it sits inside the 32mm wastegate port, to help sealing, and centering.
the flapper door is stainless steel, 34mm OD, and has a 1mm deep section that is 31.5mm OD, so it sits inside the 32mm wastegate port, to help sealing, and centering.