Is there a how to on locking our distributor?
06-08-05, 02:54 PM
#1
Boosted Fb
Thread Starter
iTrader: (1)
Join Date: Nov 2003
Location: Lost!
Posts: 1,471
Likes: 0
Received 0 Likes
on
0 Posts
Is there a how to on locking our distributor?
I wanted to lock my dizzy and was wondering if there was a write up on this yet. I searched and found nothing so I'm guessing no. How would I go about doing this?
Thanks, Ed
Thanks, Ed
06-08-05, 05:37 PM
#2
Gone Race'n
iTrader: (4)
Join Date: Dec 2001
Location: Rockford, IL
Posts: 1,544
Likes: 0
Received 0 Likes
on
0 Posts
The best way is to extend the weights and then weld them in possition. You could also replce the springs with tie/safety wire, but if the wire breaks the weights will advance the timing.
06-09-05, 10:33 AM
#6
Senior Member
Join Date: Jul 2003
Location: MN
Posts: 327
Likes: 0
Received 0 Likes
on
0 Posts
I think seanrot did an exellent tutorial => https://www.rx7club.com/1st-generation-specific-1979-1985-18/lock-distibuter-tutorial-good-job-227682/
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
joel(PA)
Race Car Tech
0
10-01-15 10:25 AM