i am wiring in my deck to a 1985 gslse and i have all the stock plugs pulled off and all the wiresstripped back but i cant seem to get my deck to work. It needs an always 12V which i found but what i cant find is a wire with 12v on acc postion on the ignition i cant find a stereo diagram in the FSM if anyone has any info please help would be great...would love to get it done today

 

audio system 1

chapter 15; pages 62-78


if no help, get a fluke and start probin'. be sure to check the fuses cause it may be blown and thats why the acc is not hot.

 

Use a test light and just find the pin that has power only when the ignition is on. No need for a multimeter for a simple radio install.

 

i dont have the fsm its a webone and thats not in it.... but ill try it with a probe i have found multipul ones with a probe that have power in the on postion but i dont know which one will work cuz when i wired it to that my deck wouldent turn on

 

can anyone tell me the colour code for power through accessory for the wiring

 

According to installdr.com:

Dash light illumination- orange
+12 volt ignition- red
power antenna- blue or blue w/white stripe
+12 volt battery- yellow

- David

 

u didnt happen to blow a fuse did you? i did and it happed to blow up my deck...just the little power light came on..luckily i ws able to return it

 

since there is already a thread on this, i want to ask, is the any wiering adapters to intstall headunits in the 84 n 85 rx7s, and if so could someone post up a link to where i could get somthng like that. or if theres a good thread on stero wireing i missed put that up too, im looking to change out the stocker unit for a boss audio head unit and speakers, any help thanx and sorry to jack

 

This site has a wiring diagram

http://www.wankel.net/~krwright/cars/rx7/manuals.html

 

84rx7gsl:

Off of the recommendation of someone on these forums I picked up a Mazda truck wiring harness kit from Circuit City that worked with the FB, but it was mostly useless. The reasons is you have to run new wiring for your speakers anyway (because of the external amp not working with new head units) so that only leaves you with the power cords.

Ground is easy, just tap into a nearby screw.

So the only thing you can use in the $20 kit are the accessory and constant power (which were labeled BACKWARDS in the kit.) If I were to do it again, I'd just pick up some connectors for 1.67 at Radio Shack instead for those two connections. Just use a multimeter or test light to see which cable is acc and which is constant.

 

i tried all of that i had found 4 wires with acc power and it still wouldent come on...my fuses are all good and the deck worked with the last car i owned. i used a multi meter. It still wont work. I am out of ideas. I have grounded it properly as well. I have no clue what esle to try. and yes i did run speaker wires becasue i was gettin so pissed off at the power not coming on. I hope my deck isnt blown. Or worse something in my car(hopefully not likely)

 

see if that pic there helps any. also if you have a constant 12 u can check 2 see if ur cd player still works by puttin ur acc and ur 12v from the cd together on the 12v in the car.

 

Go to the hardware store and get a long peice of wire. Get another wire for the ground.


Put the unit on the engine bay. Attach the battery, and the ground. If that wont work properly then the unit might be deffective.

Its a quick and easy thing to do.

Then if you figure out it works with the battery wire in the engine bay, just run a wire through the firewall. they have 10amp attachments to put at the middle of the wire. Just incase it gets to much or the wire corrodes and it grounds out.

-nick-

 

thank you everyone for taking the time to help me.... i tried to see if my deck would turn on with both the acc wire and the 12 volt constant from the deck harness plugged into the car...no luck...but my buddy came over who has the same deck and we plugged my deck into his car and it turned on.... my fuse is good in both the deck and car. My stock stero will turn on. Just tested that theroy. The picture showed what i needed thank you for that. i Guess the next step is to wire it myself i asked the question more out of being worried that something is wrong like there isnt enough power there or something. The guy before me had a deck in the car maby he changed something... i was more worried thats all. thanks agian for all your time...ime goin to work on it right now and ill post some results

 

finally got to the car after a couple of days and i got it to work jsut ended up runningmy own power. I mounted my deck inbetween the stcok one i removed the tape deck and left the equilzer and headunit. It looks pritty sweet. I also wired my sub and managed to fit 2 10 inch subs in the back(my one 10 weighs 25lbs) its not small. Box is 1 cubic foot i didnt think it would ever fit. Thankyou everyone for your time

 

im taking my sub out...its about the same size but it isnt bolted down so when im doing some sliding it likes 2 counter w/e i do....great stuff. good that you got it all going tho. go any pics?