Installing Eccentric shaft pully
09-27-06, 08:11 PM
#1
Junior Member
Thread Starter
Join Date: Sep 2006
Location: bremerton, wa
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Installing Eccentric shaft pully
OK I remove the four bolts holding the pull on a few years back and now I can't figure out how in the hell to realign the pull. I have read both my chilton and Haynes. Neather of which same anything the just tell you to remove the Center bolt which i did not do. This is on an 85 12A engine. Maybe i'm nuking this one out but for the life of me i just can't figure out how to re-align this pull so the timing marks are right. Thank you
09-27-06, 08:16 PM
#2
Burning Oil-Grinding 3rd
Serch a bit and you will find a few threads on how to do this.
I think you put the key way at 9 oclock and then put the pully back on with the timing mark.
I think you put the key way at 9 oclock and then put the pully back on with the timing mark.
09-28-06, 12:13 AM
#5
Thread
Thread Starter
Forum
Replies
Last Post
tiger18
3rd Generation Specific (1993-2002)
9
09-03-15 08:27 PM