Wolf 3D AFR datalogging???
AFR datalogging???
I'got the money for V5 (or V4 maybe) but i have a question about the A/F datalogging and reading. I seen in the wolf page the V5 is build in a/f meter, will that just require me to get the bosch 4 wire wideband and wire up to the unit??? or there its something alse require???
Passenger
Posts: n/a
to be honest with you about the software program goes the datalogging SUCKS, but at least it is a start and they are trying, i dont know if the ecu does any internal logging in the V5 but you can ask, and If i remember correct i think u need the lsu sensor?
Inmy opinion i would tell you to buy the "ultimate setup"
the innovate motorsports LC1 wb controller with sensor and gauge kit ($399)
http://www.innovatemotorsports.com/x...cat=262&page=1
AND:
add their DL-32 kit ($499)
http://www.innovatemotorsports.com/x...cat=262&page=1
man, if i had $900...... i would!!!
but if you have a laptop then you can just get their LC1 kit for ($199)
http://www.innovatemotorsports.com/products/lc1.php
Inmy opinion i would tell you to buy the "ultimate setup"
the innovate motorsports LC1 wb controller with sensor and gauge kit ($399)
http://www.innovatemotorsports.com/x...cat=262&page=1
AND:
add their DL-32 kit ($499)
http://www.innovatemotorsports.com/x...cat=262&page=1
man, if i had $900...... i would!!!
but if you have a laptop then you can just get their LC1 kit for ($199)
http://www.innovatemotorsports.com/products/lc1.php
Passenger
Posts: n/a
yes it can share sensors, but it does not have any kind of harness available, you would have to "T" into your sensor wires at your ecu, you can put duplicate sensors in if you want but i think its a waste and you would have to run new wires from your sensors to your DL32.
Thread
Thread Starter
Forum
Replies
Last Post
jibe
3rd Generation Specific (1993-2002)
3
Sep 24, 2015 11:38 AM