I have a PFS PMC + remote + original Interacq datalogging and tuning SW
PMC works great
remote works great.
Add/remove fuel OK
Add/remove advance OK
RPM limit OK
...

I tried to install Interacq with the original disks that I have (I want to do some datalogging and use the refined maps it offers).
Install OK
when I try to connect, it asks me to insert original disk one.
When I do it, it asks me the same thing again after being busy for a few seconds and hearing the disk reader reading the disk.
it continues, ever and ever.

Did someone had the same behaviour?
How do I manage to make it work?

Thanks!

 

If memory serves right, the disk was only good for one install onto a computer. I have a disk with the same problem and ended up getting a Power FC rather than fight the woes of finding an educated PFS PMC tuner.

 

I agree. Forget data logging. I street tuned mine with the help of a friend watching the controller. Dyno tuning it off the controller's feedback and exhaust sensor is the best you can get with that set up. I also had a peak/low hold 5wire afr gauge that was handy. I loved that computer, but not a lot of support for it out there anymore.

*there is a sub-forum for this over in engine management*

 

Thanks. It's les confortable but that's what I do actually.