where to get a .8-.125 oil reducer?
#1
Rotary Freak
Thread Starter
where to get a .8-.125 oil reducer?
Guys I have not been able to find a shop that carries these oil reducers. Most have the .40 but I have read that its to small and will smoke my turbo. Anyone have a supplier for these reducers?
#2
Rotary Enthusiast
iTrader: (1)
Originally Posted by Bukwild
Guys I have not been able to find a shop that carries these oil reducers. Most have the .40 but I have read that its to small and will smoke my turbo. Anyone have a supplier for these reducers?
#3
development
#4
Rotary Freak
Thread Starter
I might have to buy this one a .60 and drill it out as stated above. I would however like to find the right one that I need but I will give this a shot.
http://www.atpturbo.com/Merchant2/me...egory_Code=BCS
http://www.atpturbo.com/Merchant2/me...egory_Code=BCS
#5
IRS 4 Life
iTrader: (12)
Join Date: Feb 2001
Location: Sicklerville, South Jersey!!
Posts: 2,634
Likes: 0
Received 2 Likes
on
2 Posts
Better off getting the one from ATP and drilling it out. I did this with mine with no ill effects yet. I think the drill bit I used was 11/32? Gives you .9 but I could be wrong.
Pretty small one, make sure you do it in a drill press or watch out you don’t snap a bit in it, I snapped one of the bosh titanium’s in mine and had a bitch of a time getting it out.
The nice thing about the ATP one is its solid brass, I had previously tried to take a 1/8npt to –3 fitting fillit then drill it and it wasn’t the prettiest but worked, the Atp piece is much cleaner.
Pretty small one, make sure you do it in a drill press or watch out you don’t snap a bit in it, I snapped one of the bosh titanium’s in mine and had a bitch of a time getting it out.
The nice thing about the ATP one is its solid brass, I had previously tried to take a 1/8npt to –3 fitting fillit then drill it and it wasn’t the prettiest but worked, the Atp piece is much cleaner.
Trending Topics
#10
Rotary Freak
Thread Starter
http://www.atpturbo.com/Merchant2/me...egory_Code=BCS
I just bought this one. It says the hole is .60 so I guess I will just try and get it as close with the drill bit listed above as I can.
I just bought this one. It says the hole is .60 so I guess I will just try and get it as close with the drill bit listed above as I can.
Thread
Thread Starter
Forum
Replies
Last Post
troym55
3rd Generation Specific (1993-2002)
23
05-25-16 12:42 PM
tiger18
3rd Generation Specific (1993-2002)
9
09-03-15 08:27 PM