alright well im finally going to go for a single setup

Manifold: Late Shift cast
Turbine: Garret 60-1 P trim .70 comp 1.00 a/r
Fuel: SX 1000 hp pump , 550cc primaries 1650cc secondaries
EMS: PowerFC
Port: Street
Clutch: OSGiken twin disc & jun flywheel

I hope to get 420 whp with good spool up (max boost before 3600 rpm)

 

Sounds like a nice setup. Take lots of pics of the build, and videos when you are done, if you can.

 

thx...im contemplating the fuel pump though...if i should just run two in tank stockers also if i should run 1.15 a/r...but that'll effect spool significantly =\ so i might just stick with .70 / 1.00

 

Go for the two stock pumps - that is what I would do at least. You get about 320lph for flow, compared to the single Walbro which puts out 255lph. Plus buying another stocker, adapting it to fit, and putting in lines/fittings would cost less than the walbro.

I'm not sure if you should run 1.00 or 1.15... I'm not a turbo expert by any means.

 

hmm twin stockers it is...

1.15 a/r would give me slower spool which is a nono but more hp possibility

1.00 a/r is just what i need =)

 

Do you already have your parts.
Im thinking of selling everything. And i have everything.
93 R-1
Vince

 

yeah my parts are on order..i decided to go with twin FD pumps .70 comp p trim wheel 1.00 a/r ..but im making my own manifold

 

where did you order the os giken twin plate clutch from? i am trying to order that clutch but nobody around seems to be able to get it.

 

www.jspec.com can get it from you..i bought mine through a friend with 150 miles on it