Vp16 and 1.10A/R. I will post them asap.

 

been waiting for some parts so got a few days off..

Yesterday i received a 4" v-band clamp so i cut of the 3" flange and did some welding.






tomorrow i'll get my muffler and the pipe so by the end of the weekend im hopefully done!

 

I hope you don't mind me asking what filler rod you are using for welding the stainless(diam and material), what gas (Argon, Argon/Carbondioxide etc) and at what amps you are welding.

I tig on my own and I happen to really like the defined bead your welds have.

Thanks in advance.

Chris

 

What i normally use is .035 308 wire for stainless and 309 for stainless to steel..

Gas: Argon, i normally set the regulator at 13~15.

I also use a gas lens and usually around 35~85 amps...( depending on thickness)

 

no prob at all bro.

im using a 1,6mm 316L rod and pure argon, 2,4mm red tungsten. amps i don't know since im using the pedal for heat control..

 

Very nice welds.

 

Got some more work done today.

welding some mounts.




I had a 5" bend lying around from the downpipe build..





Still waiting for some material so this was all that i could do today.

 

that exhaust tip looks awesome

 

+1

 

holy stainless ha you must have spend five grand on all that huge tubing!!!!!!!! Looks good thought, i have to hear those twin waste gates they are prolly going to sound crazy

 

got some work done today...

i finally got my 4" pipes! i decided to try with a single muffler first..







im to cheap to buy real bends...


took a while to tig everything!



then i fired her up and i must say that im relieved that the sound wasn't as bad as i thought it would!

 

lookin' really good man.
when are you going to dyno it with the 4" exhaust?

 

looking good gus.. I'm almost finished with my 4" exhaust as well...

 

we'll see, havning some problem getting e85 since it's e75 everywhere now, don't have much fuel left in the tank!

 

going to be really interesting seeing what numbers you can pull!

next step is the 6point roll bar install..

then its time for some axles...

 

im having the same problem here Gus. Think ours might even be E70. So looks like ill only get to dyno on low boost until summer when e85 comes back unless i get my hands on something else. I only have 5 gallons of e85 left, should have saved more.

 

Very very sexy. I'm really liking that exhaust, can't wait to see some vids. Great job !

 

car looks like a rex from hell, lol. wicked manifold, turbo and wastegate setup. not sure of the dump tubes, but hey it works. post some vids soon. good work.

 

since i had a trillion 90dgr bends on my intercooler piping i felt like improving the setup.

inlet on intercooler was 2.5".



welding on 3" piping.



cutting on my newly polished parts


the rad is placed as high as possible.






i'm going to try the new pegasus clamps on this setup!

 

this is how the ic setup turned out..
minimum amount of bends and pipe length!

 

how is the clearance under the car with the intercooler pipes being that low?

 

pretty much same as before since the rad is mounted about 3inch higher.

 

very nice gus!

 

Very nice work!

 

Thanks man!

I would like to thank everyone for all nice comments!! i've learned alot during this build and i'm more than happy to share!

i just got some interior left now... then it is time for a new paint job!