Holset wh1e (hx40) on an FC
#28
Full Member
iTrader: (1)
Join Date: Jun 2011
Location: Tulsa
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
On these holset turbos can you take off the wastegate that's on them and run an external wg with them, it seems like I see them on the hot side sticking out... I'm wanting to run a synapse 50mm wg...
#29
Junior Member
Join Date: Sep 2011
Location: Melb S.E., Vic, Australia
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
i know its not an fc but this is a clip i found of a tough sounding holset running on a first gen.
http://www.youtube.com/watch?v=gXtFKukgb9g
enjoy.
http://www.youtube.com/watch?v=gXtFKukgb9g
enjoy.
#33
Can Post Only in New Member Section
Join Date: Aug 2010
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
I running an HX40 with a fully divided Manifold and Precision WG. It starts building boost at 3k and is full boost before 4k (13.5PSI) and that is on stock ports and turbo rotors! I love it.
Attachment 452093
Attachment 452094
Attachment 452093
Attachment 452094
#37
It means 12A all ways^
iTrader: (20)
Join Date: Jul 2008
Location: Northern IN
Posts: 769
Likes: 0
Received 0 Likes
on
0 Posts
Should be a fun setup! I can't wait to see it! Mine has been under the knife for the past 2 years. Rebuilding the engine again with race ports, the largest pineapple templates without going bridge, 9.4:1 rotors and the HX40. Shooting for a reliable 400rwhp at 1 bar and with the rotor/porting combo this turbo should full spool before 4k RPM.
Thread
Thread Starter
Forum
Replies
Last Post