saweet. got kinda pissed lol.

 

got the rear subframes swapped out today so now my base is sitting with lsd, 5lug and fancy 4pot brakes lol. Now just gotta get the motor in wired up and drive....

 

Bring it by whenn you get it running!

 

Does any one have a good Center iron?

 

Before and after of 86 NA housing.
not quite Ed clean lol

 

Hey whos engine is that.

 

It was mine for my 86 base. But it got traded for a turbo lol.

 

Its going in my 86 na .....I was hoping to get 300k out of the original engine but it fell just shy at about 280ish
Wanted to Bridgeport it but because Ed needs a car while his are getting finished and money is tight that's gonna have to wait....ill probably do that to the engine that is in the car currently

Figure. With the rtek ecu mod ad stock turbo injectors should be a fun little NA

 

280k miles on an original engine...wow. Are you sure it wasn't rebuilt or replaced?

Rotary >Pistons

 

Yeah pretty sure... I got it with 128k on it and everything looked original then....that was back in 00 or 01 maybe
She's been a good car!!!

 

Reaching out again... does anyone have a good NA center iron? Ive got 3 bad ones ha ha ha. till get good with welding iron they are screwed.
thanks everyone! Especially Dana the rest of you're engine with be cleaned and ready if you need it!

 

Tell Ed to get with Miguel at magic wrench.

 

My rotary stuff over the week..went to ATLANTA for new Mazda 6 training and my instructor had a bunch of cool stuff including this 4rotor E- shaft from the 792- p car
Also went to Mazmart and got a tour of the facility and this sweet 4rotor
Also started cleaning up the stock ports on my NA build

 

so does anyone have a t2 afm? almost got the car running but found out i only have n.a afms no t2s.

 

Parting out Rx7

dont wanna do it but i dont wanna blow more money fixing wrong ****, i get out of the military in 6 months and need to have some kinda money to live on......... Not leaving rotaries just gotta get better off before getting back into the 7 game.

 

looking good Myles.

 

Which one are you parting out?

 

Is your brake master cylinder good jdmwankle ?

 

Was gonna part both out but might end up finishing the white one and hopefully be ok gettin out. Yes I have a good brake master. Anyone have exhaust gaskets. Need the 2 in the rear. Also can u run a usdm s4 t2 on a jspec n318 ecu and afm?

 

ill take that cylinder off your hands.

 

Hey guys, it's been a little while since my last post but i've been away at school. I recently had a brand new single turbo wiring harness stolen from my doorstop in Savannah. Rywire sent it via USPS, and the postman confirmed that he left the package at my door. I never received the package. I reached out to all of my neighbors, but no luck. So if you see one being offered in the area, it could be the one that was stolen from me. Fortunately, Rywire is replacing the stolen harness. They are a great company.

 

That blows!!! ill keep my ear to the ground

 

hhxo where you located? do you need just the master or whole thing?

 

Im at Ft. Stewart, GA. and i just need the brake master cylinder.

 

How much for the brake booster and proportioning valve?