WhoDiddy6

iTrader: (9)

car is gettin started on this mon/tues and was just curious as to how much boost the stock turbos with stock injectors could hold? running microtech LT10S, greddy prof b spec boost controller, FMIC (24x12x3 core) with 2.5 piping. also, wut HP/TQ range should i might be in?

diddy

snowball

wrong section?

WhoDiddy6

iTrader: (9)

didn't know wut section to put this in since it's an FC.

FD3S_wanted

iTrader: (5)

I guess it's similar to a FC since the injectors are the same size. But the microtech helps.

WhoDiddy6

iTrader: (9)

forgot about the walbro fuel pump, and koyo radiator, plugs, wires. any figures?

WhoDiddy6

iTrader: (9)

Bump

WhoDiddy6

iTrader: (9)

no1 with a similar set up?

JanusRN

I imagine most of the people who frequent this site go with a single turbo. The stock twins on a 13B-re are exceptionally small.

FD3S_wanted

iTrader: (5)

I use the stock twins on my RE. I plan on boosting 15 psi but it's not tuned yet and I need a new clutch before tuning it.

FD3S_wanted

iTrader: (5)

As for power, I'm hopping to get 300 rwhp .

BTW I have 1600cc secondaries and a FD fuel pump on a streetported engine.

WhoDiddy6

iTrader: (9)

i will upgrading to SINGLE turbo sumtime next year, and i wanna get the car up and running, so these twins will be on here for a minute. gonna run upgraded fuel lines and an aeromotive fuel pressure regulator, w/o cats and w/ 3" mandrel bent turbo back. any suggestions on a single turbo kit? thinking of the cast iron HKS T04 manifold (original) with an un decided turbo.


diddy

WhoDiddy6

iTrader: (9)

also, possibly 850's all around.