Tips for removing power steering pressure line?
Thread Starter
Can Post Only in New Member Section
Joined: Mar 2018
Posts: 3
Likes: 0
From: Houston
Tips for removing power steering pressure line?
A couple of day ago I found out there is a small crack on my power steering pressure line which causes fluid leak, and I decided to replace the line by myself, it took me about less than five minutes for the first couple of screws as I work along the line down to the last one which is the fitting that connects the line and whatever is down there, I found out it was extremely difficult to get it out, any tips for getting that out? Thanks. And also is there any O-rings on the fittings? I wasn’t sure, the old one that I took off has no orings on it.
Last edited by rx7ren; Mar 8, 2018 at 01:11 AM. Reason: More questions
Thread Starter
Can Post Only in New Member Section
Joined: Mar 2018
Posts: 3
Likes: 0
From: Houston
87 fc na
its a 87rx7 NA
im trying to get the bottom one out which is hiding underneath the compressor
Not familiar with the FC's, but it looks like you should stop with the open-end wrench and get a line wrench on it. Is it accessible from any other angles? Will removing anything else first give you better access? Have you looked at the Factory Service Manual to see if it has any info?
Thread
Thread Starter
Forum
Replies
Last Post
Laz93RX7
3rd Generation Specific (1993-2002)
10
Feb 21, 2009 10:52 AM
rajeevx7
3rd Generation Specific (1993-2002)
1
Aug 15, 2004 11:28 AM
Nucklez
2nd Generation Specific (1986-1992)
1
Mar 4, 2002 03:53 PM
