Ok, just got my carb put back on and idle and air adjusted. Just for a little backround.

Now the problem is, when i step on the accelerator it gogs and then takes about a sec for it to get moving, and this moving is a slow acceleration. like if i tried to burn out, i wouldn't be able to. Kinda annoying to have a nice 1984 mazda RX7 and not be able to use the RWD. haha

Ok so any suggestions or symptom questions let me know! anything can help! THanks!

-Jake

 

what do you mean by "GOG?"

 

i mean when i step down...it will quit idling and just like momentarily die.

 

Go check the Throttle cable make sure there is no lag in between.

 

Maybe too much throttle pump.. make sure all vacuum hoses are connected, especially vacuum advance

Carby's suck....

 

welcome to the board?

what carburetor?

where is the timing?

 

@diabolical
Ok the carb is a nicki carb.
The timing is about a millimeter off, pretty dang close.
And thank you i am pretty proud to have a car that is considered special. I just hope i can get it running smoothly. -__-

ok a lot of hoses are missing from the carb air filter head. none are connected to that. all the other lines are correct on the actual carburater.

and i went out and started it today and about three minutes into warm up id tap the accelerator and it would die. not till about 8-10 minutes into warm up would it actual rev the engine. but there would still be that Gog.

hope this helps.

Thank you!

 

you're probably chasing a small vacuum leak, and because of it, your mixture is probably off, too.