S4 actuators and VDI question.
#1
Can Post Only in New Member Section
Thread Starter
Join Date: Apr 2012
Location: Hamel, MN
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
S4 actuators and VDI question.
I recently got a engine for an 86 shell that I have had for a few years. Got the engine in and it runs fine, however I do not have exhaust yet and will not be running a stock system. I have removed the ACV and want to use the stock air pump to run the actuators, I have seen how many of you are running them my question is where/what is the VDI?
#2
Top Down, Boost Up
iTrader: (7)
VDI is an S5 NA feature. An S4 NA engine only has the 6PI system, which is the 2 actuators on the lower intake manifold.
This is how I controlled my 6PI system with w/ an RPM switch (and later the VDI when I converted to S5 manifolds): https://www.rx7club.com/2nd-generation-specific-1986-1992-17/activating-aux-ports-vdi-rpm-switches-907824/
Images of the S5 manifold here: http://homepage.mac.com/carldavis/intake.html
This is how I controlled my 6PI system with w/ an RPM switch (and later the VDI when I converted to S5 manifolds): https://www.rx7club.com/2nd-generation-specific-1986-1992-17/activating-aux-ports-vdi-rpm-switches-907824/
Images of the S5 manifold here: http://homepage.mac.com/carldavis/intake.html
#3
Can Post Only in New Member Section
Thread Starter
Join Date: Apr 2012
Location: Hamel, MN
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Thank you! yeah I was searching around and saw how you did it.... wasn't sure what the VDI was. this is very helpful I am working on a set-up like yours should have it finalized by the weekend. Thanks again!
Thread
Thread Starter
Forum
Replies
Last Post
24seven_dada
3rd Generation Specific (1993-2002)
20
11-10-18 12:03 PM
alexdimen
3rd Generation Specific (1993-2002)
20
10-23-15 01:50 PM