Microtech timming not advancing
#2
Rotary Freak
iTrader: (8)
Make sure first your tps is calibrated correctly. And it is going from 00 to a higher number as soon as you touch the throttle.
Next.
Check yout opt_TIMmax and make sure its on at least 40 degrees.
Next
Check your opt_TIMtrm is set to 0
Next check your opt_Static is set to 0
And just check one more time your timing lock is off. And you should be ok
Next.
Check yout opt_TIMmax and make sure its on at least 40 degrees.
Next
Check your opt_TIMtrm is set to 0
Next check your opt_Static is set to 0
And just check one more time your timing lock is off. And you should be ok
#3
you are the ****. my timming max was set to 0 and i set it to 40 and it worked perfect. i guess that the tunner that i went to didnt know what they were dooing on microtech they realy only deal with haltech.
thanks rx72c, evertime you come to save my ***. youre the **** thanks again
thanks rx72c, evertime you come to save my ***. youre the **** thanks again
Thread
Thread Starter
Forum
Replies
Last Post
SRTx781
3rd Generation Specific (1993-2002)
6
12-19-15 07:30 PM