As soon as i go above 3300(where i have secondaries set up at) car will lean out and buck like crazy. It hits like 15afr. This only happends in 1st and sometimes 2nd gear. Car runs good in 3rd gear and above, it is set up at 10.5AFR right now and climing as RPMs rise. I have the car setup in normal mode right now. What can i adjust so it will actually go in 1st gear so it wont cut out.

 

what's the primary/secondary size?
staging %?
etc...

 

550/1600

95%

they come on at 3300

 

what kind of fuel pump?
you might try bumping it all the way up to 99%

 

walbo 255, im going to try to bump it up to 99% and see what that does tommorow

 

if you can, try running it uber-rich right before it stages and see if that helps out a little.

 

i finally got it figured out, since i was useing hand controller i didnt realize what i was doing with the 2,4 and 6psi maps and i was only concentraining on 8 and 10psi maps. I had to use hand controller because i am useing zietronix wideband and it uses a serial port. but the lower psi maps were set really rich and then 10psi maps were good. so i fixed it so its a nice smooth curved line and i have mo more hesitation. I also set stage to 99%

 

cool beans