kev807

has anyone used the zeal pnp and if so how well did it work work and should i spend the 500 or go for a ms2 and diy it i know how to solder and im good with 12v wiring so it shouldnt be to much of a problem but some one give me some information

muythaibxr

I use a zeal PnP all the time :-P

evfan42

When I first picked up the megasquirt to do a setup on my 86 corolla a while ago I didnt know a thing about soldering, I spent a little time researching the technique and some time testing it on the relay and stim boards. When I felt I was getting good enough to solder the megasquirt itself I made sure I followed every instruction closely. It took me about 8-10 hours but it ran up correctly on the first try. I think that as long as you spend your time making sure you got the proper technique of soldering and the patience to sit down and follow the instructions I think you would probably do just fine with assembling the megasquirt.

-xlr8planet-

iTrader: (3)

op, you should listen to muythaibxr (ken)















he invented the zeal board

muythaibxr

I'm actually working on a new adapter to work with the MS3+MS3x for sequential staged injection. That and you can use the MS3+MS3x+v3 board with *no modification* to run the engine assuming the ms3x VR conditioner doesn't have any noise issues with the VR signal.